|
|
|
|
|
Grzegorz Struzikiewicz
An effective chip formation process is significant for an efficient metal-cutting process. Long continuous chips can lead to scratches on the machined surface, increasing the risk to operator safety and stability of the machining process. The use of chip...
ver más
|
|
|
|
|
|
|
|
|
|
|
Dan Xu, Yunxiao Guo, Zhongyi Yu, Zhenfeng Wang, Rongze Lan, Runhao Zhao, Xinjia Xie and Han Long
Flocking for fixed-Wing Unmanned Aerial Vehicles (UAVs) is an extremely complex challenge due to fixed-wing UAV?s control problem and the system?s coordinate difficulty. Recently, flocking approaches based on reinforcement learning have attracted attenti...
ver más
|
|
|
|
|
|
|
|
|
|
|
Jaroslaw Chodór, Leon Kukielka, Grzegorz Chomka, Lukasz Bohdal, Radoslaw Patyk, Marek Kowalik, Tomasz Trzepiecinski and Andrii M. Radchenko
This article concerns the application of the FEM method for the prediction of stress and deformation states in the workpiece during diamond sliding burnishing (DSB). An updated Lagrange (UL) description was used to describe the phenomena at a typical inc...
ver más
|
|
|
|
|
|
|
|
|
|
|
Rika Dwi Hidayatul Qoryah, Agil Widhy Azizi, Mahros Darsin
Pág. 256 - 269
The cutting fluid is one of the essential factors in machining to increase machinability. The issuance of ISO 14000 about reducing the use of cutting fluid for its danger for operator and environment has encouraged many researchers to find ways to minimi...
ver más
|
|
|
|
|
|
|
|
|
|
|
Andreas Tausendfreund, Dirk Stöbener and Andreas Fischer
In order to study the mechanical loads of a workpiece in manufacturing processes such as single-tooth milling, in-process measurements of workpiece deformations are required. To enable the resolution of shock waves due to the mechanical impact of the too...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zhaolong Zhu, Dietrich Buck, Xiaolei Guo, Pingxiang Cao and Mats Ekevad
This paper investigated the machinability of a stone?plastic composite (SPC) via orthogonal cutting with diamond cutters. The objective was to determine the effect of cutting depth on its machinability, including cutting forces, heat, chip formation, and...
ver más
|
|
|
|
|
|
|
|
|
|
|
Yassmin Seid Ahmed, Jose Mario Paiva, Danielle Covelli and Stephen Clarence Veldhuis
In this study, the wear mechanisms and tribological performance of uncoated and coated carbide tools were investigated during the turning of super duplex stainless steel (SDSS)?Grade UNS S32750, known commercially as SAF 2507. The tool wear was evaluated...
ver más
|
|
|
|
|
|