ARTÍCULO
TITULO

One-Dimensional Annular Diffuser Model for Preliminary Turbomachinery Design

Roberto Agromayor    
Bernhard Müller and Lars O. Nord    

Resumen

Annular diffusers are frequently used in turbomachinery applications to recover the discharge kinetic energy and increase the total-to-static isentropic efficiency. Despite its strong influence on turbomachinery performance, the diffuser is often neglected during the preliminary design. In this context, a one-dimensional flow model for annular diffusers that accounts for the impact of this component on turbomachinery performance was developed. The model allows use of arbitrary equations of state and to account for the effects of area change, heat transfer, and friction. The mathematical problem is formulated as an implicit system of ordinary differential equations that can be solved when the Mach number in the meridional direction is different than one. The model was verified against a reference case to assess that: (1) the stagnation enthalpy is conserved and (2) the entropy computation is consistent and it was found that the error of the numerical solution was always smaller than the prescribed integration tolerance. In addition, the model was validated against experimental data from the literature, finding that deviation between the predicted and measured pressure recovery coefficients was less than 2% when the best-fit skin friction coefficient is used. Finally, a sensitivity analysis was performed to investigate the influence of several input parameters on diffuser performance, concluding that: (1) the area ratio is not a suitable optimization variable because the pressure recovery coefficient increases asymptotically when this variable tends to infinity, (2) the diffuser should be designed with a positive mean wall cant angle to recover the tangential fraction of kinetic energy, (3) the mean wall cant angle is a critical design variable when the maximum axial length of the diffuser is constrained, and (4) the performance of the diffuser declines when the outlet hub-to-tip ratio of axial turbomachines is increased because the channel height is reduced.

 Artículos similares

       
 
Xavier Flete, Nicolas Binder, Yannick Bousquet and Sandrine Cros    
In the current study, full-stage unsteady simulations were performed to investigate rotating instability inception mechanisms in a particularly large tip clearance centrifugal compressor with a vaneless diffuser and a volute. Four operating points along ... ver más

 
Lorenzo Tieghi, Giovanni Delibra, Johan van der Spuy and Alessandro Corsini    
Air-cooled condensers (ACCs) are commonly found in power plants working with concentrated solar power or in steam power plants operated in regions with limited water availability. In ACCs, the flow of air is driven toward the heat exchangers by axial fan... ver más

 
Thomas Carolus and Konrad Bamberger    
This study targets determining impellers of impeller-only axial fans with an optimal hub-to-tip ratio for the highest achievable total-to-static efficiency. Differently from other studies, a holistic approach is chosen. Firstly, the complete class of the... ver más

 
Zhenyu Xu and Shen Yan    
This article proposes an progressive-collapse mechanism for suspended-dome structures subjected to cable rupture, based on experimental and finite element results. The anti-collapse mechanism can be succinctly described as a node-buckling mechanism: the ... ver más
Revista: Buildings

 
Pedro Leite Ferreira and Dídia Isabel Cameira Covas    
The current paper aims at assessing the effect of the radial mesh on the description of the axial velocity in steady-state and transient conditions and at presenting the results of a new optimized equal-area mesh. For this purpose, a quasi-2D model is im... ver más
Revista: Water