|
|
|
|
|
Ioan Petrovai, Otto Todor-Boer, Adriana Vulpoi, Leontin David and Ioan Botiz
In this study, we have employed a film deposition technique based on convective forces acting at the triple air?solution?substrate contact line to tune the rate of solvent evaporation and, thus, to exert control over the morphology of the resulting mixed...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zeyulin Zhang, Yanshuang Ba, Dazheng Chen, Pengru Yan, Qingwen Song, Yuming Zhang, Weidong Zhu, Chunfu Zhang and Yue Hao
All-inorganic perovskites, with their low-cost, simple processes and superior heat stability, have become potential candidate materials for photodetectors (PDs). However, they have no representative responsivity in the deep-ultraviolet (UV) wavelength re...
ver más
|
|
|
|
|
|
|
|
|
|
|
Yujin Kim, Sung Hwan Joo, Seong Gwan Shin, Hyung Wook Choi, Chung Wung Bark, You Seung Rim, Kyung Hwan Kim and Sangmo Kim
Normal perovskite solar cells (PSCs) consist of the following layers: transparent electrode, electron-transport layer (ETL), light-absorbing perovskite layer, hole-transport layer (HTL), and metal electrode. Energy, such as electricity, is produced throu...
ver más
|
|
|
|
|
|
|
|
|
|
|
Muhazri Abd Mutalib, Norasikin Ahmad Ludin, Mohd Sukor Su?ait, Matthew Davies, Suhaila Sepeai, Mohd Asri Mat Teridi, Mohamad Firdaus Mohamad Noh and Mohd Adib Ibrahim
High-performance electron transport layer (ETL) anode generally needs to form a uniform dense layer with suitable conduction band position and good electron transport properties. The TiO2 photoanode is primarily applied as the ETL because it is low-cost,...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ahmed Hayali, Roger J. Reeves and Maan M. Alkaisi
The efficiency and stability of perovskite solar cells (PSCs) depend not only on the perovskite film quality, but they are also influenced by the charge carriers of both the electron and hole transport layers (ETL and HTL). Doping of the carrier transpor...
ver más
|
|
|
|
|
|
|
|
|
|
|
Keke Song, Xiaoping Zou, Huiyin Zhang, Chunqian Zhang, Jin Cheng, Baoyu Liu, Yujun Yao, Xiaolan Wang, Xiaotong Li, Yifei Wang and Baokai Ren
The electron transport layer (ETL) is critical to carrier extraction for perovskite solar cells (PSCs). Moreover, the morphology and surface condition of the ETL could influence the topography of the perovskite layer. ZnO, TiO2, and SnO2 were widely inve...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zhenhuang Su, Chenyue Wang, Guanhaojie Zheng and Xingyu Gao
Blending perovskite with different cations has been successful in improving performance of perovskite solar cells, but the complex pathway of perovskite crystal formation remains a mystery, hindering its further development. In this paper, the detailed c...
ver más
|
|
|
|
|
|
|
|
|
|
|
Luana Mazzarella, Anna B. Morales-Vilches, Lars Korte, Rutger Schlatmann and Bernd Stannowski
Doped hydrogenated nanocrystalline (nc-Si:H) and silicon oxide (nc-SiOx:H) materials grown by plasma-enhanced chemical vapor deposition have favourable optoelectronic properties originated from their two-phase structure. This unique combination of qualit...
ver más
|
|
|
|
|
|
|
|
|
|
|
Haifeng Yang, Hui Wang, Jincheng Zhang, Jingjing Chang and Chunfu Zhang
Solvent engineering is one of the most widely applied preparation methods for the high- quality perovskite films. In this method, the choice of anti-solvent plays a very important role to improve the perovskite crystal quality. Here, we report a facile w...
ver más
|
|
|
|
|
|
|
|
|
|
|
Arjaan Kooijman, Loreta A. Muscarella and René M. Williams
Doping lead perovskite materials with a few percent of zinc-halides increases their stability at ambient conditions, enhances their properties and improves the efficiency of the corresponding solar cell devices.
|
|
|
|
|
|