152   Artículos

 
en línea
Wolfgang Tillmann, Lukas Wojarski, Christian Hopmann, Patricia Fatherazi and Christian Timmer    
This paper investigates if the polar groups induced by a plasma treatment can increase the lap shear strength of laser-joined metal and plastic hybrids. Optimal laser joining parameters for cold-rolled AISI304?polyamide 6.6 and sandblasted AISI304?polypr... ver más
Revista: Applied Sciences    Formato: Electrónico

 
en línea
Shih-Hung Lin, Chen-Ying Su and Hsu-Wei Fang    
The goal of this paper is to examine the use of pig blood in the industrial mass production of platelet dry powder and to transform platelet dry powder into a low-cost and mass-produced material. Platelet-rich plasma (PRP) and platelet-rich fibrin (PRF) ... ver más
Revista: Applied Sciences    Formato: Electrónico

 
en línea
Evgeniya Ermakova, Sergey Sysoev, Irina Tsyrendorzhieva, Alexander Mareev, Olga Maslova, Vladimir Shayapov, Eugene Maksimovskiy, Irina Yushina and Marina Kosinova    
We report an investigation into 1,4-Bis-N,N-(trimethylsilyl)piperazine (BTMSP) as a novel precursor for the synthesis of silicon carbonitride films by chemical vapor deposition (CVD). The thermal stability, temperature dependence of vapor pressure and th... ver más
Revista: Coatings    Formato: Electrónico

 
en línea
Andrea Frazzitta, Alberto Bacci, Arianna Carbone, Alessandro Cianchi, Alessandro Curcio, Illya Drebot, Massimo Ferrario, Vittoria Petrillo, Marcello Rossetti Conti, Sanae Samsam, Luca Serafini and Andrea Renato Rossi    
X-ray production through betatron radiation emission from electron bunches is a valuable resource for several research fields. The EuAPS (EuPRAXIA Advanced Photon Sources) project, within the framework of EuPRAXIA, aims to provide 1?10 keV photons (X-ray... ver más
Revista: Instruments    Formato: Electrónico

 
en línea
Chenghao Yu, Jifei Ye, Hao Chang, Weijing Zhou, Xiao Han, Mingyu Li and Heyan Gao    
The ejection of the plasma plume produced by laser ablation is an important process for inducing mechanical effects. Therefore, in this paper, the characteristics of the plasma plume are investigated in order to analyze the impulse coupling mechanism wit... ver más
Revista: Aerospace    Formato: Electrónico

 
en línea
Amir Abdullaev, Alexander Kotvitskii, Ivan Moralev and Maxim Ustinov    
Cancellation of the cross-flow vortices in a swept-wing boundary layer is attempted by plasma actuator array in numerical simulation. The response of the boundary layer to the stationary excitation by a single actuator section is measured experimentally ... ver más
Revista: Aerospace    Formato: Electrónico

 
en línea
Qi Liu, Yong Li, Yanlin Hu and Wei Mao    
The objective of this study is to investigate the effects of a magnetic field gradient on the performance of a magnetically shielded Hall thruster. The Particle-in-cell with Monte Carlo collision method (PIC-MCC) is used to simulate the discharge process... ver más
Revista: Aerospace    Formato: Electrónico

 
en línea
Pavel Polivanov, Oleg Vishnyakov and Andrey Sidorenko    
The problem of flow control under conditions of a turbulent boundary layer at transonic and supersonic free-stream velocities is considered. Such flows are integral components of the flight process and exert significant effects on the flow around both th... ver más
Revista: Aerospace    Formato: Electrónico

 
en línea
Rubing Liu, Shenghui Xue, Wentao Wei, Qi Lin and Kun Tang    
Conventional plasma synthetic jet actuators rely only on jet orifice for suction when functioning for long durations. A limited supplementary gas leads to jet velocity reduction and weakening of the flow control ability. Therefore, this study proposes an... ver más
Revista: Aerospace    Formato: Electrónico

 
en línea
Aleksandr A. Firsov    
This paper presents the results of testing and optimization of a plasma-assisted combustion scheme based on a pylon for fuel injection equipped with a plasma actuator. Electrodes were installed behind the stern of the pylon for the creation of Q-DC disch... ver más
Revista: Aerospace    Formato: Electrónico

« Anterior     Página: 1 de 11     Siguiente »