|
|
|
|
|
Mohammad Hafiz Hersyah,Desta Yolanda,Nela Fatma
Pág. 175 - 181
Cleaning and drying cocoa beans are generally done manually by farmers. The manual cleaning process takes a long time, and the pulp reduction is not optimal. In contrast, drying using sunlight takes a long time when it is done in the rainy season. This c...
ver más
|
|
|
|
|
|
|
|
|
|
|
Dong Min Kim, Soon Ho Hong, Se Hyeon Jeong and Sun Je Kim
The interest in wind-assisted ship propulsions (WASPs) is increasing to improve fuel efficiency and to reduce greenhouse gas emissions in ships. A rotor sail, one of the typical WASPs, can provide auxiliary propulsive force by rotating a cylinder-shaped ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ran Li, Jie Gong, Wei Chen, Jie Li, Wei Chai, Chang-kyu Rheem and Xiaobin Li
Numerical simulations are carried out to investigate the vortex-induced vibrations of a two-degree-of-freedom (2DOF) near-wall rotating cylinder. Considering the effects of gap ratio, reduced velocity and rotational rate, the amplitude response, wake var...
ver más
|
|
|
|
|
|
|
|
|
|
|
Gustavo Luis Bianchi, Verónica Acosta and Carlos Seijas
Specific applications for the oil and gas industry. Testing of corrosion inhibitors to select the one with the best performance simulating field conditions.
|
|
|
|
|
|
|
|
|
|
|
Zhiteng Zhou, Yi Liu, Hongping Wang and Shizhao Wang
A mass-conserved formulation for the Ffowcs-Williams?Hawkings (FW?H) integral is proposed to suppress contributions of spurious mass flux to the far-field sound at very low Mach numbers. The far-field condition and compact-source region assumptions are e...
ver más
|
|
|
|
|
|
|
|
|
|
|
Rafel Roig, Xavier Sánchez-Botello and Xavier Escaler
Part 2 of this work presents a numerical methodology, validated using the experimental results presented in Part 1, to calculate the added modal coefficients of a submerged cylinder in water both when it oscillates and when it rotates with a whirling mot...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ming Zhao and Erfan Taheri
Control of flow past a circular cylinder using a rotating control rod is investigated by conducting two-dimensional numerical simulations with a Reynolds number of 200, a rod-to-cylinder diameter ratio of 0.2, a gap ratio of 0.2, position angles of the c...
ver más
|
|
|
|
|
|
|
|
|
|
|
Te Song, Xin Liu and Feng Xu
In this paper, the entire process of the flow around a fixed square cylinder and the moving surface boundary-layer control (MSBC) at a low Reynolds number was numerically simulated. Two small rotating circular cylinders were located in each of the two re...
ver más
|
|
|
|
|
|
|
|
|
|
|
A. Rashkovan, S.D. Amar, U. Bieder and G. Ziskind
The present paper provides a physically sound numerical modeling of liquid flows experimentally observed inside a vertical circular cylinder with a stationary envelope, rotating bottom and open top. In these flows, the resulting vortex depth may be such ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Yutaka Nakano, Tsubasa Kishi and Hiroki Takahara
Chatter is more likely to occur during the turning process of a thin-walled cylindrical workpiece owing to the low rigidity of such workpieces. Chatter causes intensive vibration, deterioration of the surface finish accuracy, tool damage, and tool wear. ...
ver más
|
|
|
|
|
|