|
|
|
Hao Wu, Zhezheng Wu, Weimin Song, Dongwei Chen, Mei Yang and Hang Yuan
Due to the issue of weakened adhesion between ultra-thin surface overlays, higher demands have been placed on bonding layer materials in practical engineering. This study proposed a method for preparing a one-component waterborne epoxy resin-modified emu...
ver más
|
|
|
|
|
|
|
Huayang Yu, Yihao Deng, Guansen Deng and Niya Dong
Fatigue failure in asphalt pavements, caused by continuous loading, primarily occurs at the interface between the asphalt binder and the aggregate (adhesive failure) or within the asphalt binder itself (cohesive failure). This study conducted variable st...
ver más
|
|
|
|
|
|
|
Hao Sun, Yingshuai Liu and Jianwei Tan
There is increasing demand for the on-board diagnosis of lubricating oils. In this research, we consider various sensor principles for on-board diagnosis of the thermal aging of engine oils. One of the parameters investigated is the viscosity of the lubr...
ver más
|
|
|
|
|
|
|
Xue Qi, Heebo Ha, Byungil Hwang and Sooman Lim
Printing technology enables not only high-volume, multipurpose, low-impact, low-cost manufacturing, but also the introduction of flexible electronic devices, such as displays, actuators, and sensors, to a wide range of consumer markets. Consequently, in ...
ver más
|
|
|
|
|
|
|
Hongmei Li, Jiwang Jiang, Song Li and Xiang Ma
Asphalt mastic is a combination of binder and filler. The binder-filler system within asphalt mixtures plays an important role in adhesion between mineral aggregates. The aging of binders in pavement always happens with fillers inside or contact with min...
ver más
|
|
|
|
|
|
|
The development of a new drilling fluid system with hydrate inhibition is of great significance for drilling safety in gas hydrate-bearing sediments. Considering the importance of the selection of a suitable thickener for drilling fluid systems under wea...
ver más
|
|
|
|
|
|
|
K A Obaid , S. R Rassol , A. J Hussain , A. O Musa
Pág. 1 - 7
Introduction: Its necessary to bear in mind that we live in the word increase industrialization, therefore we make any modifications to the material to getting on best characterizations. The aim of this research is to Prepare new Pseudo Plasticity Polyme...
ver más
|
|
|
|