|
|
|
|
|
Xianquan Wang, Yong Qiu, Jie Yuan, Dongyan Liu, Peiyu Shi, Chenchen Zhao, Shanyuan Xu and Tengfei Zhao
Spatial truss structures (STSs), serving as the bottom support structure of a cooling tower, effectively harness the superior load-bearing capacity offered by lattice-type truss structures. STSs are composed of main bars, diagonal bars, and horizontal ba...
ver más
|
|
|
|
|
|
|
|
|
|
|
Fangyuan Li, Zhenwei Guo, Peifeng Wu and Yunxuan Cui
This study proposes two curves that depict the vehicle?bridge contact force in a novel transportation system named AERORail, which is a lightweight cable-supported structure in which the rails and the prestressed cable form the load bearing system. Based...
ver más
|
|
|
|
|
|
|
|
|
|
|
Chen Chen, Hong Zhou, Zhengda Lv and Ziqiu Li
Plated grillage with combined openings was susceptible to complex failure behaviors as the main load-bearing structure of the superstructure on passenger ships subjected to deck loads. Additionally, the deformation and stresses generated during the weldi...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zhen Xu, Lianjiang Xu, Junfeng Sun, Meihong Liu, Taohong Liao and Xiangping Hu
Flexible support cylindrical gas film seals (CGFSs) adapt well to rotor whirling and have a good gas lubrication effect during thermal deformation. However, when a CGFS operates under the ?three high? (high interface slip speed, high-pressure differentia...
ver más
|
|
|
|
|
|
|
|
|
|
|
Iurii Vakaliuk, Silke Scheerer and Manfred Curbach
In the case of solid slabs made from reinforced concrete that are usually subjected to bending, large areas of the structure are stressed well below their load-bearing capacity or remain stress-free. Contrary to this are shell structures, which can bridg...
ver más
|
|
|
|
|
|
|
|
|
|
|
Gui Cheng, Tianrui Ma, Jun Yang, Nan Chang and Xiang Zhou
Morphing trailing edge wing as an important morphing wing technology has gained wide attention because of its advantages, such as gust mitigation, improved aerodynamic efficiency, and reduced radar reflective area. However, the key problems such as low l...
ver más
|
|
|
|
|
|
|
|
|
|
|
Stefano Piacquadio, Dominik Pridöhl, Nils Henkel, Rasmus Bergström, Alessandro Zamprotta, Athanasios Dafnis and Kai-Uwe Schröder
Economic viability of small launch vehicles, i.e., microlaunchers, is impaired by several factors, one of which is a higher dry to wet mass ratio as compared to conventional size launchers. Although reusability may reduce launch cost, it can drive dry an...
ver más
|
|
|
|
|
|
|
|
|
|
|
Qi Zhang, Chenhao Zhang, Yifeng Lin, Yuanhai Li, Yixin Shen and Yuechao Pei
In recent years, offshore wind turbine technology has been widely developed, making a significant contribution to the advancement of renewable energy. Due to the predominant subsurface geological composition characterized by rocky formations in some mari...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ziyu Xu, Tianhe Gao, Zengcong Li, Qingjie Bi, Xiongwei Liu and Kuo Tian
As the key load-bearing component of spacecraft, the strength evaluation of stiffened plate structures faces two challenges. On the one hand, the simulation results are sometimes inaccurate, due to the simplification of the true loading conditions and mo...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ali Mekhtiyev, Yelena Neshina, Aliya Alkina, Vyacheslav Yugay, Valeriy Kalytka, Yermek Sarsikeyev and Lalita Kirichenko
This paper presents the results of complex scientific research aimed at developing a prototype fiber-optic system for controlling the technical condition of buildings, structures, and extended objects. The aim is to develop a quasi-distributed type of fi...
ver más
|
|
|
|
|
|