|
|
|
|
|
B. Megala Devi, Samyuktha Guruprasath, Pooraniammal Balu, Anirudha Chattopadhyay, Siva Sudha Thilagar, Kanaga Vijayan Dhanabalan, Manoj Choudhary, Swarnalatha Moparthi and A. Abdul Kader Jailani
Recent advancements in molecular biology have revolutionized plant disease diagnosis and management. This review focuses on disease diagnosis through serological techniques, isothermal amplification methods, CRISPR-based approaches, and management strate...
ver más
|
|
|
|
|
|
|
|
|
|
|
Denan Zhao, Simon Cooper, Parmjit Chima, Guobin Wang, Lechun Zhang, Binshu Sun, Xuejian Zhang and Yubin Lan
Utilizing agricultural UAVs for pesticide and insecticide spraying is an effective measure for plant protection. However, achieving effective coverage on the back side of target is often challenging. To address this issue, this study combined a contact-c...
ver más
|
|
|
|
|
|
|
|
|
|
|
Gamal El Afandi, Hossam Ismael and Souleymane Fall
Pesticides have been widely used in agriculture, resulting in significant pollution that affects both the environment and human health. This pollution is particularly prevalent in nearby agricultural areas, where sensitive resources are contaminated thro...
ver más
|
|
|
|
|
|
|
|
|
|
|
Xiulan Bao, Yuxin Niu, Yishu Li, Jincheng Mao, Shanjun Li, Xiaojie Ma, Qilin Yin and Biyu Chen
In Southeast Asia, many varieties of citrus are grown in hilly areas. Compared with plain orchards, it is difficult for large spraying equipment to move in hilly orchards. Small spraying equipment can enter hilly orchards, but their spraying power cannot...
ver más
|
|
|
|
|
|
|
|
|
|
|
Chenchen Gu, Chunjiang Zhao, Wei Zou, Shuo Yang, Hanjie Dou and Changyuan Zhai
Orchard spraying can effectively control pests and diseases. Over-spraying commonly results in excessive pesticide residues on agricultural products and environmental pollution. To avoid these problems, variable spraying technology uses target canopy det...
ver más
|
|
|
|
|
|
|
|
|
|
|
Jun-Soo Kim, Won-Ju Lee, Van Chien Pham and Jae-Hyuk Choi
A numerical study was carried out to investigate the effects of injector spray angle (SA) and injection position (IP) on the combustion and emission characteristics of a two-stroke ME-GI marine engine at full load. Three-dimensional (3D) simulations of t...
ver más
|
|
|
|
|
|
|
|
|
|
|
Xiaopeng Xie and Yinan Wang
This work aims to study the influence of the spraying parameters on the spray flow field and coating thickness distribution during the air spraying process. The shaping air pressure and the target geometry have an important influence on the distribution ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Adnan Darwish Ahmad, Ahmad M. Abubaker, Ahmad A. Salaimeh and Nelson K. Akafuah
Electrostatic rotary bell sprayers (ERBSs) are widely used in the automotive industry. In ERBS, atomization is facilitated using centrifugal forces which disintegrate the paint film inside the cup into droplets at the cup edge. The droplets are then tran...
ver más
|
|
|
|
|
|
|
|
|
|
|
Francesca Petronella, Antonella Pagliarulo, Alessandra Truppi, Mariateresa Lettieri, Maurizio Masieri, Angela Calia, M. Lucia Curri and Roberto Comparelli
A colloidal route was exploited to synthesize TiO2 anisotropic nanocrystal rods in shape (TiO2 NRs) with a surface chemistry suited for their dispersibility and processability in apolar organic solvents. TiO2 NRs were dispersed in chloroform and n-hepta...
ver más
|
|
|
|
|
|
|
|
|
|
|
Qiaoyan Ye and Karlheinz Pulli
This paper presents a numerical simulation of the spray painting process using a pneumatic atomizer with the help of a computational fluid dynamics code. The droplet characteristics that are necessary for the droplet trajectory calculation were experimen...
ver más
|
|
|
|
|
|