|
|
|
|
|
Weiyuan Zhu, Jiaqi Cheng, Yutao Pang, Hongbin An, Junpeng Zou, Jie Ren and Cheng Zhang
This study proposes a new form of underground diaphragm wall foundation with hexagonal sections, called the grid pile foundation (GPF), which is used for long-span bridges. To investigate the lateral bearing capacity characteristics of the integrated pil...
ver más
|
|
|
|
|
|
|
|
|
|
|
Siyu Wang and Jie Jia
The large-span bridge is highly sensitive to temperature and wind loads. Therefore, it is essential to study the bridge?s fatigue life under the combined effects of temperature and static wind loads. This study focuses on the main bridge of Qiao Jia-fan ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Massimiliano Pepe, Domenica Costantino and Vincenzo Saverio Alfio
The aim of the paper is to identify a suitable method for assessing the deformation of structures (buildings, bridges, walls, etc.) by means of topographic measurements of significant targets positioned on the infrastructure under consideration. In parti...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zehua Zhang, Wenle Gao and Yuming Kou
Micro-parameter calibration is essential in constructing an accurate and reliable numerical model of particle discrete element PFC3D 6.0 software. Micro-parameter calibration is mainly accomplished according to the macro-parameters obtained from static o...
ver más
|
|
|
|
|
|
|
|
|
|
|
Baogui Zhou, Huabin Zhong, Kaipeng Yang, Xueqiang Yang, Chifeng Cai, Jie Xiao, Yongjian Liu and Bingxiang Yuan
Based on a real engineering case, this study employs the MIDAS finite element software to model the reinforced high embankment slope using anti-sliding piles. The accuracy of the finite element method is verified by comparing calculated outcomes with fie...
ver más
|
|
|
|
|
|
|
|
|
|
|
Mark A. Denisenko, Alina S. Isaeva, Alexander S. Sinyukin and Andrey V. Kovalev
The fast, convenient, and accurate determination of railroad cars? load mass is critical to ensure safety and allow asset counting in railway infrastructure. In this paper, we propose a method for modeling the mechanical deformations that occur in the ra...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ihtisham Khalid, Vasilis Maglogiannis, Dries Naudts, Adnan Shahid and Ingrid Moerman
Cooperative communications advancements in Vehicular-to-Everything (V2X) are bolstering the autonomous driving paradigm. V2X nodes are connected through communication technology, such as a short-range communication mode (Dedicated Short Range Communicati...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zhongchu Tian and Binlin Xu
As important load-bearing structures, suspension cables have been widely used in suspension bridges, engineering ropeways, cable suspension systems and other special equipment. Their dynamic problems have always been a research hotspot. Especially for co...
ver más
|
|
|
|
|
|
|
|
|
|
|
Manuel Moya, David Sánchez, José Ángel Romero and José Ramón Villar-García
The loads generated inside agricultural silos under static and dynamic conditions depend on the mechanical properties of the materials stored inside them. Silo calculation methodologies are based on these mechanical properties. Although it is known that ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Qi Yan, Chao Yang and Zhiqiang Wan
This study investigates and compares various multivariate regression methods, including principal component regression (PCR) and partial least squares regression (PLSR), for flight load analysis and demonstrates their high learning efficiency and strong ...
ver más
|
|
|
|
|
|