126   Artículos

 
en línea
M. I. Rodríguez-Tapiador, J. M. Asensi, M. Roldán, J. Merino, J. Bertomeu and S. Fernández    
Copper nitride (Cu3N) has gained significant attention recently due to its potential in several scientific and technological applications. This study focuses on using Cu3N as a solar absorber in photovoltaic technology. Cu3N thin films were deposited on ... ver más
Revista: Coatings    Formato: Electrónico

 
en línea
Mara Bruzzi, Naomi Falsini, Nicola Calisi, Paolo Scardi and Anna Vinattieri    
CsPbCl3 perovskite is attracting increasing interest in ultraviolet (UV) detection due to its optical band gap and superior intrinsic optoelectronic properties. In this study, a novel one-step magnetron sputtering technique was applied for fabricating Cs... ver más
Revista: Coatings    Formato: Electrónico

 
en línea
Xiaolei Ye, Huan Luo, Ming Hou, Pierre Bertrand, Alain Billard and Pascal Briois    
Revista: Coatings    Formato: Electrónico

 
en línea
Soyoung Kim, Jung-Hwan In, Seon Hoon Kim, Karam Han, Dongkook Lim, Yun Sik Hwang, Kyung Min Lee and Ju Hyeon Choi    
SiO2/Nb2O5 multilayer thin films were designed for the special application of an aviation lighting system emitting green light. For optical components in this system to meet requirements such as a high transmittance and durability, SiO2/Nb2O5 multilayer ... ver más
Revista: Applied Sciences    Formato: Electrónico

 
en línea
Sahand Behrangi, Ivo Sedlácek, Ján ?terba, Gabriela Suková, Zsolt Czigány, Vilma Bur?íková, Pavel Soucek, Vjaceslav Sochora, Katalin Balázsi and Petr Va?ina    
Pathogenic microbes, such as bacteria and viruses, can spread quickly via contaminated surfaces. Most of these pathogenic microorganisms can survive on surfaces for a long time. Touching these surfaces can lead to the transmission of the microorganisms t... ver más
Revista: Coatings    Formato: Electrónico

 
en línea
Tao Wang, Yifan Wang, Qi Cheng, Shouming Yu and Guojun Zhang    
CrNx coatings with a low nitrogen content below 31.7 at.% were deposited using closed field unbalanced magnetron sputtering by varying the N2:Ar flow ratio. A dense and column-free CrNx coating was obtained at a nitrogen content of 14.8 at.%, whereas the... ver más
Revista: Coatings    Formato: Electrónico

 
en línea
Qiujin Wang, Guozhong Zhao and Hai Wang    
The high-temperature annealing effect of a V2O5/Al2O3 bilayer on the reflectivity of visible band was studied in the present work. It was found that the V2O5 (200 nm)/Al2O3 (30 nm) sample (A-0) has a nano-granular surface morphology without a definite cr... ver más
Revista: Coatings    Formato: Electrónico

 
en línea
Rafal Chodun, Bartosz Wicher, Katarzyna Nowakowska-Langier, Roman Minikayev, Marlena Dypa-Uminska and Krzysztof Zdunek    
This paper presents the experimental results of high-temperature sputtering of nickel targets by the Gas Injection Magnetron Sputtering (GIMS) technique. The GIMS technique is a pulsed magnetron sputtering technique that involves the generation of plasma... ver más
Revista: Coatings    Formato: Electrónico

 
en línea
Haixiao Fang, Hongjian Zhao and Jining He    
In this study, Ti/Cu multilayer film was deposited by magnetron sputtering and then nitrided at 800 and 900 °C in N2. The microstructure and wear performance were studied. The deposited Ti/Cu multilayer film mainly consisted of Ti and Cu phases. After ni... ver más
Revista: Coatings    Formato: Electrónico

 
en línea
Zhen Zhou, Yanfeng Han and Jin Qian    
Water lubrication has been widely used in marine equipment, where rubber bearings and seals suffer intense friction and severe wear under mixed and boundary conditions. It has good research prospects and practical value to study the composite of amorphou... ver más
Revista: Coatings    Formato: Electrónico

« Anterior     Página: 1 de 11     Siguiente »