|
|
|
|
|
Karidewa Nyeinga, Ole J Nydal, Denis Okello, Eldad J.K.B. Banda
This study presents a dynamic model for a concentrating solar energy collector with an integrated rock bed heat storage system. The model is based on numerical integration of a set of conservation equations for mass, momentum and energy of the heat carri...
ver más
|
|
|
|
|
|
|
|
|
|
|
Nicola Casari, Ettore Fadiga, Stefano Oliani, Mattia Piovan, Michele Pinelli and Alessio Suman
Automotive fans, small wind turbines, and manned and unmanned aerial vehicles (MAVs/UAVs) are just a few examples in which noise generated by the flow?s interaction with aerodynamic surfaces is a major concern. The current work shows the potential of a n...
ver más
|
|
|
|
|
|
|
|
|
|
|
Seong Hyun Hong, Young Jin Kim, Soo Hyung Park, Sung Nam Jung and Ki Ro Kim
The air and structural loads of a 5-ton class light helicopter (LH) rotor in a 2.24 g pull-up maneuver are investigated using a coupling between the computational structural dynamics (CSD) and computational fluid dynamics (CFD) methods. The LH rotor is c...
ver más
|
|
|
|
|
|
|
|
|
|
|
Stefano Mini, Fabrizio Ponti, Alessandro Brusa, Roberto Bertacin and Barbara Betti
Numerical studies intended to predict solid rocket motors anomalies are the major contributors when developing strategies to both limit expensive fire tests and to investigate and understand the physical phenomena from which anomalies can arise. This pap...
ver más
|
|
|
|
|
|
|
|
|
|
|
Hauke Witte, Christoph Bode and Jens Friedrichs
Typically installed in a rotor-only configuration, low-pressure axial fans discharge directly into a free atmosphere and the discharge shows a strong swirl component. Since such designs, without guide vanes, cannot convert the dynamic pressure in the swi...
ver más
|
|
|
|
|
|
|
|
|
|
|
Márton Veress and Kálmán Péntek
This study interprets the development of various flow types of the Transdanubian Mountains. For this, pressure was calculated at different depths and along some profiles the horizontal, specific temperature was calculated based on geoisotherms. This is t...
ver más
|
|
|
|
|
|
|
|
|
|
|
Charles R. Ortloff
High-speed fluid flows over roughened surfaces occur in many engineering applications; one important application involves high velocity water flows in pipelines with roughened interior walls where the wall roughness affects head loss estimates necessary ...
ver más
|
|
|
|
|
|
|
|
|
|
|
M. R. Ajith Kumar, Jaan H. Pu, Prashanth R. Hanmaiahgari and Martin F. Lambert
A problem with 1-D water hammer modelling is in the application of accurate unsteady friction. Moreover, investigating the time response of fluid dynamics and unsteady turbulence structures during the water hammer is not possible with a 1-D model. This r...
ver más
|
|
|
|
|
|
|
|
|
|
|
Jonathan Tyrer, Chrysothemis Paraskevopoulou, Ravi Shah, Richard Miller and Michael Kavvadas
Urban tunnelling can be highly challenging, especially in areas where limited ground settlements and environmental disturbance is required. Mechanised tunnelling is usually preferred in such ground environments, specifically Slurry or EPBM (Earth Pressur...
ver más
|
|
|
|
|
|
|
|
|
|
|
Min-Su Kim, In-Hoi Koo, Keon-Hyeong Lee, Eun-Sung Lee, Hyung-Seok Han, Seung-Min Jeong, Holak Kim and Jeong-Yeol Choi
This experimental investigation focused on the ignition and combustion characteristics of a tandem cavity-based scramjet combustor with side-by-side identical cavities. This study utilized the Pusan National University-direct connect scramjet combustor (...
ver más
|
|
|
|
|
|