|
|
|
|
|
Liang Yang, Miaoer Liu, Yun Liu, Tao Zhang, Hailong Lu, Qingzhen Lu and Jun Yan
A cryogenic hose is used to transport liquefied natural gas at sea, where flexible fittings are sealed by corrugated lining and end flange welding. However, the extreme cryogenic temperatures of the conveyed fluid introduce substantial challenges to the ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Yuxuan Xia, Jingxia Yue, Jiankang Lei, Ke Yang and Yordan Garbatov
The welding residual stress re-distribution behavior during fatigue crack propagation in butt-welded high-strength steel plates for ship construction is investigated based on experimental test results and numerical analyses. The specimens? initial weldin...
ver más
|
|
|
|
|
|
|
|
|
|
|
Sayako Kodera, Leander Schmidt, Florian Römer, Klaus Schricker, Saichand Gourishetti, David Böttger, Tanja Krüger, András Kátai, Benjamin Straß, Bernd Wolter and Jean Pierre Bergmann
With the increasing power and speed of laser welding, in-process monitoring has become even more crucial to ensure process stability and weld quality. Due to its low cost and installation flexibility, acoustic process monitoring is a promising method and...
ver más
|
|
|
|
|
|
|
|
|
|
|
Klaus Schricker, Leander Schmidt, Hannes Friedmann and Jean Pierre Bergmann
The development of adaptive and intelligent clamping devices allows for the reduction of rejects and defects based on weld discontinuities in laser-beam welding. The utilization of fixture-integrated sensors and actuators is a new approach, realizing ada...
ver más
|
|
|
|
|
|
|
|
|
|
|
Jaemin Lee, Diego Perrera and Hyun Chung
In this article, a layered shell element-based, elastic finite element method for predicting welding distortion in multi-pass welding is developed. The welding distortion generated in each pass can be predicted by employing layer-by-layer equivalent plas...
ver más
|
|
|
|
|
|
|
|
|
|
|
Woo-Jae Seong, Sang-Cheol Park and Hee-Keun Lee
We propose an analytical model for the fast prediction of angular distortion that is caused by practical multilayer (or multi-pass) butt welding under constraints. To this end, the relationships between angular distortion, bead size, thickness, and degre...
ver más
|
|
|
|
|
|
|
|
|
|
|
Miikka Karhu, Veli Kujanpää, Harri Eskelinen and Antti Salminen
In thick section laser welding, filler metal addition is usually required to improve joint fit-up tolerances or to control the chemical composition of the weld metal. With deep and narrow welds produced using an over-alloyed filler metal, it may be chall...
ver más
|
|
|
|
|
|
|
|
|
|
|
Rudi Winarno,Daryono Daryono,Moh. Jufri
Pág. 113 - 118
This experiment was conducted on the influence of welding process with ampere range variation and weld joints toward ST-40 shear strength. Furthermore, welded specimen is tested with tensile test. Method of this experiment is testing shear strength by us...
ver más
|
|
|
|
|
|
|
|
|
|
|
Brown, D; Neuman, J
Pág. 33 - 37
|
|
|
|
|
|