|
|
|
|
|
Munsu Kim, Lorena Perez-Andrade, Luke N. Brewer and Gregory W. Kubacki
This paper investigates the effect of the microstructure on the corrosion behavior of cold sprayed (CS) AA5083 compared to its wrought counterpart. It has been shown that the microstructure of CS aluminum alloys, such as AA2024, AA6061, and AA7075, affec...
ver más
|
|
|
|
|
|
|
|
|
|
|
Henryk Kania and Anzelina Marek
Zn-Al-Mg-Si coatings are an excellent alternative to conventional hot-dip galvanizing coatings. Their high corrosion resistance in corrosive environments containing chlorides and CO2 is well recognized. But sulfur dioxide is also an important stimulator ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zofia Szweda and Dominik Czachura
The consequences of the loss of the load-bearing capacity due to the corrosion of prestressing steel can be much more dangerous than in the case of reinforced concrete structures, since failure can occur quite rapidly and without warning. A very importan...
ver más
|
|
|
|
|
|
|
|
|
|
|
Qingli Ding, Hrishikesh Das, Piyush Upadhyay, Bryer C. Sousa, Kubra Karayagiz, Adam Powell and Brajendra Mishra
Friction stir welded (FSW) aluminum?magnesium lightweight vehicle joints have gained significant interest due to their high strength-to-weight ratio. In this work, the corrosion resistance of this material is analyzed through electrochemical tests, which...
ver más
|
|
|
|
|
|
|
|
|
|
|
Jaehui Bang and Eunkyung Lee
In this study, the surface properties of marine structures were improved by applying a twin wire arc spray process to high-strength low alloys. The effect of Al and Mo contents in Ni-Al coatings on their mechanical and corrosion behaviors was analyzed us...
ver más
|
|
|
|
|
|
|
|
|
|
|
Mónica Echeverry-Rendón, Luisa F. Berrio, Sara M. Robledo, Jorge A. Calderón, Juan G. Castaño and Felix Echeverría
Magnesium (Mg) has been explored during the last few decades in the biomedical industry as a biodegradable implant. However, mechanical properties and corrosion resistance are still big concerns for clinical use. Therefore, this study proposes a suitable...
ver más
|
|
|
|
|
|
|
|
|
|
|
Fernanda Martins Queiroz, Aline de Fátima Santos Bugarin, Victor Hugo Ayusso, Maysa Terada and Isolda Costa
The AA 2198-T851 is a third-generation Al-Li alloy developed for use in the aircraft industry. Al-Li alloys are susceptible to localized corrosion due to their complex microstructure resulting from the used thermomechanical treatment. In order to prevent...
ver más
|
|
|
|
|
|
|
|
|
|
|
Matteo Di Virgilio, Andrea Basso Peressut, Valeria Arosio, Alessandro Arrigoni, Saverio Latorrata and Giovanni Dotelli
Despite being the most employed polymer electrolyte for proton exchange membrane fuel cells (PEMFCs), Nafion® has several limitations: expensiveness, poor performance when exposed to temperatures higher than 80 °C, and its potential as a source of enviro...
ver más
|
|
|
|
|
|
|
|
|
|
|
Miguel Castilla-Barbosa, Orlando Rincón-Arango and Manuel Ocampo-Terreros
The zeta potential of soils is an electric potential in the double-layer interface and is a physical property exhibited by any particle related to electrochemical attractive forces. On the other hand, the chemical aging phenomenon is seen as the chief me...
ver más
|
|
|
|
|
|
|
|
|
|
|
Hongwei Deng, Bokun Zhao, Yigai Xiao and Guanglin Tian
The response characteristics of the mesostructure and macro-characteristics of the soil?rock mixture under repeated freeze?thaw action have an important influence on the safety and stability of the dump slope in low-temperature environments. In order to ...
ver más
|
|
|
|
|
|