|
|
|
|
|
Panagiotis D. Kordas, George N. Lampeas and Konstantinos T. Fotopoulos
The main purpose of this study comprises the design and the development of a novel experimental configuration for carrying out tests on a full-scale stiffened panel manufactured of fiber-reinforced thermoplastic material. Two different test-bench design ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zhen Xu, Lianjiang Xu, Junfeng Sun, Meihong Liu, Taohong Liao and Xiangping Hu
Flexible support cylindrical gas film seals (CGFSs) adapt well to rotor whirling and have a good gas lubrication effect during thermal deformation. However, when a CGFS operates under the ?three high? (high interface slip speed, high-pressure differentia...
ver más
|
|
|
|
|
|
|
|
|
|
|
Kangshen Xiang, Weijie Chen, Siddiqui Aneeb and Weiyang Qiao
Future UHBR (Ultra-High Bypass-Ratio) engines might cause serious ?turbine noise storms? but, at present, turbine noise prediction capability is lacking. The large turning angle of the turbine blade is the first major factor deserving special attention. ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Hanqiao Han, Yun Long and Jinqing Zhong
When we tested the water jet propulsion pump, we found that there were significant vibrations in the pump, especially at small flow points that deviated from the design conditions. The water jet propulsion pump is a mixed-flow pump with guide vane, which...
ver más
|
|
|
|
|
|
|
|
|
|
|
Xinfan Yin, Hongxu Ma, Xianmin Peng, Guichuan Zhang, Honglei An and Liangquan Wang
In order to simulate the flight state of the helicopter effectively, it is necessary to trim the helicopter during the forward flight in a wind tunnel test. Previously, due to the lack of an internal-control closed loop in the test rig, the helicopter-wi...
ver más
|
|
|
|
|
|
|
|
|
|
|
Manuel Ernesto Maqueo Martínez, Stefan Schippling, Markus Schatz and Damian M. Vogt
Considerable progress has been achieved in recent decades in understanding the phenomena related to the onset of condensation in steam flows, both experimentally and especially numerically. Nevertheless, there is still a certain disagreement between the ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Florent Grotto, Christophe Bouvet, Bruno Castanié and Joël Serra
Aeronautical composite primary structures must evidence sufficient residual strength in the presence of damage for compliance with damage tolerance requirements. The study of stiffener debonding on panels subjected to compression after impact is performe...
ver más
|
|
|
|
|
|
|
|
|
|
|
Yangjing Wang, Jinquan Huang, Muxuan Pan and Wenxiang Zhou
The variable cycle engine switches working modes by way of changing variable-geometry components to achieve the dual advantages of high unit thrust and low specific fuel consumption. Due to the lack of a large amount of rig test data and the complex mode...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ahsan Tanveer and Sarvat Mushtaq Ahmad
Pitch control of an unmanned aerial vehicle (UAV) using fluidic thrust vectoring (FTV) is a relatively novel technique requiring no moving control surfaces, such as elevators. In this paper, the authors? previous work on the characterization of a static ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Chao Fu, Kuan Lu, Qian Li, Yuandong Xu, Fengshou Gu, Andrew D. Ball and Zhaoli Zheng
The engine system is critical for a marine vehicle, and its performance significantly affects the efficiency and safety of the whole ship. Due to the harsh working environment and the complex system structure, a marine system is prone to have many kinds ...
ver más
|
|
|
|
|
|