|
|
|
|
|
Suzana Petrovic, Nevena Bo?inovic, Vladimir Rajic, Danijela Stanisavljevic Ninkovic, Danilo Kisic, Milena J. Stevanovic and Emmanuel Stratakis
Arranged patterns obtained via ultrafast laser processing on the surface of Ti/Cu/Ti/Si and Ti/Zr/Ti/Si thin-film systems are reported. Two differently designed multilayer thin films Ti/Cu/Ti/Si and Ti/Zr/Ti/Si were deposited on silicon using the ion spu...
ver más
|
|
|
|
|
|
|
|
|
|
|
Borhan Albiss and Mohammad Al-Widyan
This study presents the numerical simulation, optimization, preparation, and characterization of Cu(In, Ga)Se2 (CIGS) thin-film solar cells (TFSCs). Different cell parameters were investigated, including Ga/(Ga+In) (GGI) ratios, the thicknesses of CIGS a...
ver más
|
|
|
|
|
|
|
|
|
|
|
M. I. Rodríguez-Tapiador, J. M. Asensi, M. Roldán, J. Merino, J. Bertomeu and S. Fernández
Copper nitride (Cu3N) has gained significant attention recently due to its potential in several scientific and technological applications. This study focuses on using Cu3N as a solar absorber in photovoltaic technology. Cu3N thin films were deposited on ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Satwik Kundu, Rupshali Roy, M. Saifur Rahman, Suryansh Upadhyay, Rasit Onur Topaloglu, Suzanne E. Mohney, Shengxi Huang and Swaroop Ghosh
The size of transistors has drastically reduced over the years. Interconnects have likewise also been scaled down. Today, conventional copper (Cu)-based interconnects face a significant impediment to further scaling since their electrical conductivity de...
ver más
|
|
|
|
|
|
|
|
|
|
|
Chen Lin, Teng Zhan, Junxi Wang, Jinmin Li, Zhiqiang Liu and Xiaoyan Yi
Conventionally, Cu is preferred over Al to fabricate integrated inductors with higher quality factors on either silicon or sapphire substrates, profiting from its lower resistivity. However, after investigating and comparing these two kinds of metal mult...
ver más
|
|
|
|
|
|
|
|
|
|
|
Slawomir Gulkowski and Ewelina Krawczak
Thin film Cu(In,Ga)Se2 (CIGS)-based solar cells with relatively high efficiency and low material usage might become a promising alternative for crystalline silicon technology. The most challenging task nowadays is to decrease the PV module fabrication co...
ver más
|
|
|
|
|
|
|
|
|
|
|
Alexandr Burmenko,Natalya Deyneko,Irina Hrebtsova,Igor Kryvulkin,Olga Prokopenko,Roman Shevchenko,Olexandr Tarasenko
Pág. 56 - 61
Film solar cells have been investigated to meet the need for an alternative system of electricity supply during the elimination and prevention of an emergency when an electricity supply system is damaged. Given the high degradation resistance of cadmium ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Guo-Ju Chen, Sheng-Rui Jian and Jenh-Yih Juang
In this study, Cu-doped ZnO (CZO) thin films were grown on glass substrates by using the radio frequency magnetron sputtering technique. The effects of Cu doping on the structural, surface morphological, optical properties, and wettability behaviors of C...
ver más
|
|
|
|
|
|
|
|
|
|
|
Philipus N. Hishimone, Hiroki Nagai, Masato Morita, Tetsuo Sakamoto and Mitsunobu Sato
A Cu thin film on a quartz glass substrate was fabricated by a wet process involving heat-treatment of a precursor film spray-coated with an aqueous ammonia solution containing Cu(HCOO)2·4H2O and Cu(II) complex of ethylenediamine-N,N,N′N′-tet...
ver más
|
|
|
|
|
|
|
|
|
|
|
Richard Krumpolec, Tomá? Homola, David C. Cameron, Josef Humlícek, Ondrej Caha, Karla Kuldová, Raul Zazpe, Jan Prikryl and Jan M. Macak
Sequentially pulsed chemical vapour deposition was used to successfully deposit thin nanocrystalline films of copper(I) chloride using an atomic layer deposition system in order to investigate their application to UV optoelectronics. The films were depos...
ver más
|
|
|
|
|
|