|
|
|
|
|
Seong Hyun Hong, Young Jin Kim, Soo Hyung Park, Sung Nam Jung and Ki Ro Kim
The air and structural loads of a 5-ton class light helicopter (LH) rotor in a 2.24 g pull-up maneuver are investigated using a coupling between the computational structural dynamics (CSD) and computational fluid dynamics (CFD) methods. The LH rotor is c...
ver más
|
|
|
|
|
|
|
|
|
|
|
Yucheng Yang, Guohua Xu, Yongjie Shi and Zhiyuan Hu
This study develops a hybrid solver with reversed overset assembly technology (ROAT), a viscous vortex particle method (VVPM), and a CFD program based on the URNS method, in order to study the aerodynamic and acoustic characteristics of coaxial rigid rot...
ver más
|
|
|
|
|
|
|
|
|
|
|
Lin Zhang, Junli Yang, Tiecheng Duan, Jie Wang, Xiuyi Li and Kunyuan Zhang
A new idea of nosebleed air jets with strong coupled internal and external flow is put forward using the lateral jet control principle to improve the maneuverability and fast reaction capabilities of hypersonic vehicles. The hypersonic vehicle?s nose sta...
ver más
|
|
|
|
|
|
|
|
|
|
|
Yu-Been Lee and Jae-Sang Park
This present study investigates the effect of blade tip configurations, such as the sweepback angle and anhedral angle, on the performance and hub vibratory loads for the lift-offset coaxial rotor of a 30,000-pound-class high-speed long-range utility hel...
ver más
|
|
|
|
|
|
|
|
|
|
|
Songyan Tian, Yanhui Duan and Hongbo Chen
To facilitate future Hypersonic Flight Vehicle (HFV) implementation with high maneuverability throughout its reentry trajectory, an Active Jets-Matrix (AJM) is designed to serve as the flapless pitch control surface. The AJM consists of four control grou...
ver más
|
|
|
|
|
|
|
|
|
|
|
Pan Zhou, Renliang Chen, Ye Yuan and Cheng Chi
The aerodynamic interference between the different components of quad-tiltrotor (QTR) aircraft were considered to analyze its influence on trim characteristics. A comprehensive method with the fixed-wake model was developed for multiple aerodynamic inter...
ver más
|
|
|
|
|
|
|
|
|
|
|
Dimitris Ntouras, George Papadakis and Kostas Belibassakis
Flapping foils for augmenting thrust production have drawn attention as a means of assisting ship propulsion in waves due to their high efficiency rate compared to traditional screw propellers. However, they can also offer substantial resistance reductio...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ivana Martic, Nastia Degiuli, Andrea Farkas and Ivan Gospic
Added resistance in waves is one of the main causes of an increase in required power when a ship operates in actual service conditions. The assessment of added resistance in waves is important from both an economic and environmental point of view, owing ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Rasul Niazmand Bilandi, Simone Mancini, Luigi Vitiello, Salvatore Miranda and Maria De Carlini
In the current article, the hydrodynamic forces of single-stepped planing hulls were evaluated by an analytical method and compared against towing tank tests. Using the 2D + T theory, the pressure distribution over the wedge section entering the water an...
ver más
|
|
|
|
|
|
|
|
|
|
|
Stefano Parmeggiani, Jens Peter Kofoed and Erik Friis-Madsen
The paper presents the results of an experimental study identifying the response of a 1.5 MW Wave Dragon to extreme conditions typical of the DanWEC test center. The best strategies allowing for a reduction in the extreme mooring tension have also been i...
ver más
|
|
|
|
|
|