|
|
|
|
|
Wei-Kai Gu, Chen-Wei Yang and Chang-Ming Liaw
This paper presents an electric vehicle (EV) switched reluctance motor (SRM) drive with incorporated operation capabilities integrated into the utility grid, the microgrid, and another EV. The motor drive DC-link voltage is established from the battery t...
ver más
|
|
|
|
|
|
|
|
|
|
|
Yanbo Li, Pu Yin and Junshuo Chen
The equalization technique is a key technique in the secondary utilization of retired batteries. In this paper, a double-layer equalization method is proposed, which combines the reconfigurable topology with the converter active equalization method. The ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ryan Peter Mckenzie
The upgrade of the ATLAS hadronic tile-calorimeter (TileCal) Low-Voltage Power Supply (LVPS) falls under the high-luminosity LHC upgrade project. This article serves to provide an overview of the development of a burn-in test station for a Phase-II upgra...
ver más
|
|
|
|
|
|
|
|
|
|
|
Evi Keramida, George Souliotis, Spyridon Vlassis and Fotis Plessas
This paper presents a novel inductorless dual-mode buck-boost charge pump (CP) based DC-DC converter. The proposed architecture allows the same circuit to accomplish two modes of operation, buck and boost, for degrading or elevating the output voltage, r...
ver más
|
|
|
|
|
|
|
|
|
|
|
Nikolay Hinov and Tsvetana Grigorova
The main objective of this article is to propose a rational methodology for designing multi-phase step-down DC-DC converters, which can find applications both in engineering practice and in power electronics education. This study discusses the main types...
ver más
|
|
|
|
|
|
|
|
|
|
|
Hsiao-Hsing Chou, Jian-Yu Chen, Tsung-Hu Tseng, Jun-Yi Yang, Xuan Yang and San-Fu Wang
In this paper, a new control scheme for buck converters was proposed. The buck converter utilizes the dual control loop to improve transient response and has the constant switching frequency. The control scheme is mainly as follows: (a) The switch-ON tim...
ver más
|
|
|
|
|
|
|
|
|
|
|
Klaus Röbenack and Stefan Palis
The classical buck converter is a very common DC?DC converter, which reduces an higher input supply voltage to a lower output load voltage. Replacing the inductor and the capacitor by a transmission line, we obtain a distributed buck converter, which can...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ryan Mckenzie, Roger van Rensburg, Seyedali Moeyedi, Edward Nkadimeng, Stanislav Nemecek, Juan Buritica Yate, Haleh Hadavand and Bruce Mellado
The upgrade of the A Toroidal LHC ApparatuS (ATLAS) hadronic Tile Calorimeter (TileCal) Low-Voltage Power Supply (LVPS) forms a part of the Phase-II Upgrade preparations undertaken by the ATLAS experiment for the data taking during the High-Luminosity La...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ke Li, Xuan Meng and Xiaodong Sun
In recent years, electric vehicles have developed rapidly. However, many electric cars are equipped with permanent magnet synchronous motors. Permanent magnet synchronous motors have several disadvantages: For example, permanent magnets tend to demagneti...
ver más
|
|
|
|
|
|
|
|
|
|
|
Hugot Pichon, Yves Lembeye and Jean-Christophe Crebier
In this article, inductor loss models are developed based on the experimental characterization of off-the-shelf components. The modelling steps and techniques are described and validated. It is shown that the model exhibits fairly good accuracy over a la...
ver más
|
|
|
|
|
|