|
|
|
|
|
Totok Suwanda,Rudy Soenoko,Yudy Surya Irawan,Moch Agus Choiron
Pág. 38 - 43
In the previous study, Continuous Drive Friction Welding (CDFW) had been investigated to determine the strength of joining, burn off, and temperature distribution. In this study, Dissimilar Metal CDFW was studied to assess temperature cycle analysis. Alu...
ver más
|
|
|
|
|
|
|
|
|
|
|
Aladin Eko Purkuncoro,Rudy Soenoko,Dionysius Joseph Djoko Herry Santjojo,Yudy Surya Irawan
Pág. 24 - 29
Battery waste is one of waste that can damage the environment and there has not been much good processing in Indonesia. Even though, battery waste contains carbon which can be used as a target material for deposition of carbon films using plasma sputteri...
ver más
|
|
|
|
|
|
|
|
|
|
|
Rudy Soenoko,Purnami Purnami
Pág. 24 - 36
Bowl bladed kinetic turbine has a low performance. This is a simple turbine, easy to make, easy to install and inexpensive. Kinetic turbines are made specifically for rural areas which may be far from technology facilities. The reason why this kind of tu...
ver más
|
|
|
|
|
|
|
|
|
|
|
Yurianto Yurianto,Pratikto Pratikto,Rudy Soenoko,Wahyono Suprapto
Pág. 43 - 51
Components for combat vehicles need (such as body panzers, main battle tank, armored personnel carrier) to be made of high strength and hardness steel. However, during and after the welding process is complete, this steel often leaves cracks. Quenched an...
ver más
|
|
|
|
|
|
|
|
|
|
|
Sudjatmiko Sudjatmiko,Rudy Soenoko,Agus Suprapto,Moch Agus Choiron
Pág. 54 - 60
The research on the lathe process has described that the tool nose radius parameter is one of the factors that has an influence on surface roughness in the form of product quality. Chip slenderness ratio is an important parameter in the lathe process tha...
ver más
|
|
|
|
|
|
|
|
|
|
|
Yurianto Yurianto,Pratikto Pratikto,Rudy Soenoko,Wahyono Suprapto
Pág. 55 - 61
The need for quenched and tempered steel increased, especially for the manufacture of the combat vehicle components. This steel is classified as high-strength and hardness and is bullet-resistant steel (armor steel). Maintaining the stability of steel ha...
ver más
|
|
|
|
|
|
|
|
|
|
|
Hadi Saroso,I.N.G. Wardana,Rudy Soenoko,Nurkholis Hamidi Views: 840 | | Language: ENG | DOI: 10.14710/ijred.3.3.155-160
Pág. 155 - 160
|
|
|
|
|
|