ARTÍCULO
TITULO

Demonstration of Diode-Pumped Yb:LaF3 and Tm,Ho:LaF3 Lasers

Chun Li    
Yuxin Leng    
Shanming Li and Yin Hang    

Resumen

Diode-pumped solid-state lasers using novel Yb:LaF3 and Tm,Ho:LaF3 crystals as laser gain materials are demonstrated herein. The Yb:LaF3 and Tm,Ho:LaF3 crystals were grown using the Bridgman method. By matching their absorption bands, continuous-wave laser operations were achieved for the first time. The Yb:LaF3 laser obtained a maximum average output power of 1.19 W with dual wavelengths of 1028 nm and 1033 nm. The maximum average output power and slope efficiency of the Tm,Ho:LaF3 laser were 574 mW and 18.5%, respectively. The Tm,Ho:LaF3 laser exhibited two peaks at 2043 nm and 2048 nm. Both the Yb:LaF3 and Tm,Ho:LaF3 crystals were confirmed to be laser gain materials.

Palabras claves

 Artículos similares

       
 
Jungho Lee, Ingyu Lee, Seongphil Woo, Yeoungmin Han and Youngbin Yoon    
The spray and combustion characteristics of a gas-centered swirl coaxial (GCSC) injector used in oxidizer-rich staged combustion cycle engines were analyzed. The study focused on varying the recess ratio, presence of gas swirl, and swirl direction to imp... ver más
Revista: Aerospace

 
Ranran Huang, Tao Xue and Jie Wu    
A two-point cylindrical-focused laser differential interferometer (2P-CFLDI) system and a conventional Z-type Schlieren were used to measure the hypersonic turbulent boundary layer on a flat plate at Mach number Ma = 6 and Reynolds number Re = 1.08 × 106... ver más
Revista: Aerospace

 
Paolo Caccianiga, Saverio Ceraulo, Gérard Rey, Dario Monai, Marco Baldoni and Gianluigi Caccianiga    
Introduction: Within the field of periodontology, there has been a proposal for the utilization of noninvasive laser therapy as a potential treatment for persistent periodontitis. The Laser-Assisted New Attachment Procedure (LANAP) employs an Nd:YAG lase... ver más
Revista: Applied Sciences

 
Ruilin Liu, Yunqi Liu, Hongming Liu, Yuanxing Li, Hui Chen and Zongtao Zhu    
Laser?MIG hybrid welding?brazing was used to weld 304 stainless steel and 6061-T6 aluminum alloy with a thickness of 2 mm. The microstructure, morphology, chemical composition and corrosion behavior of the samples after high-temperature oxidation were in... ver más
Revista: Applied Sciences

 
Jordi Renau Martínez, Víctor García Peñas, Manuel Ibáñez Arnal, Alberto Giménez Sancho, Eduardo López González, Adelaida García Magariño, Félix Terroba Ramírez, Francisco Javier Moreno Ayerbe and Fernando Sánchez López    
This article presents the design and manufacturing of a hydrogen-powered unmanned aquatic surface vehicle (USV) hull. The design process comprised three stages: (1) defining the requirements for a preliminary geometry, (2) verifying the hydrodynamic hull... ver más