Inicio  /  Water  /  Vol: 8 Núm: 6 Par: 0 (2016)  /  Artículo
ARTÍCULO
TITULO

Flume Experiments for Optimizing the Hydraulic Performance of a Deep-Water Wetland Utilizing Emergent Vegetation and Obstructions

Shang-Shu Shih    
Shang-Shang Hong    
Tsang-Jung Chang    

Resumen

Constructed ponds and wetlands are widely used in urban areas for stormwater management, ecological conservation, and pollution treatment. The treatment efficiency of these systems is strongly related to the hydrodynamics and hydraulic residence time. In this study, we developed a physical model and used rhodamine-WT as a tracer to conduct flume experiments. An equivalent Reynolds number was assumed, and the flume was a 1/25-scale model. Emergent obstructions (EOs), submerged obstructions (SOs), and high- and low-density emergent vegetation were placed along the sides of the flume, and 49 tracer tests were performed. We altered the density, spatial extent, aspect ratio, and configurations of the obstructions and emergent vegetation to observe changes in the hydraulic efficiency of a deep-water wetland. In the cases of low-aspect-ratio obstructions, the effects of the EOs on the hydraulic efficiency were significantly stronger than those of the SOs. In contrast, in the cases of high-aspect-ratio obstructions, the improvement effects of the EOs were weaker than those of the SOs. The high-aspect-ratio EOs altered the flow direction and constrained the water conveyance area, which apparently caused a short-circuited flow phenomenon, resulting in a decrease in hydraulic efficiency. Most cases revealed that the emergent vegetation improved the hydraulic efficiency more than the EOs. The high-density emergent vegetation (HEV) improved the hydraulic efficiency more than the low-density emergent vegetation (LEV). Three cases involving HEV, two cases involving LEV, and one case involving EOs attained a good hydraulic efficiency (? > 0.75). To achieve greater water purification, aquatic planting in constructed wetlands should not be overly dense. The HEV configuration in case 3-1 achieved optimum hydraulic performance for compliance with applicable water treatment standards.

 Artículos similares

       
 
Jun Wang, Bo Yang, Bingchen Liang, Zai-Jin You, Zhenlu Wang and Zhaowei Wang    
In this study, laboratory experiments were conducted to investigate the influence of changes in storm wave height and water level on beach response in a medium-scale wave flume. A schematic storm was simulated (rising, apex, and waning phases). A non-int... ver más

 
Morhaf Aljber, Han Soo Lee, Jae-Soon Jeong and Jonathan Salar Cabrera    
In tsunami studies, understanding the intricate dynamics in the swash area, characterised by the shoaling effect, remains a challenge. In this study, we employed the adaptive mesh refinement (AMR) method to model tsunami inundation and propagation in the... ver más

 
Rui Wang and Guoliang Yu    
In this study, the bedform dimensions of an alluvial bed in a unidirectional flow were experimentally investigated. A series of flume experiments was conducted; 700 sets of flume and field data were used in developing formulae for predicting the bedform ... ver más
Revista: Water

 
Oliver Schlömer and Jürgen Herget    
Local scour holes are erosional bed structures that are related to different scientific disciplines in Earth science and hydraulic engineering. Local scouring at naturally placed boulders is ubiquitous, but many competing factors make it difficult to iso... ver más
Revista: Water

 
Sara Dionísio António, Jebbe van der Werf, Erik Horstman, Iván Cáceres, José Alsina, Joep van der Zanden and Suzanne Hulscher    
This paper presents new data from large-scale wave flume experiments. It shows the beach profile evolution and sediment transport for two different bed slopes (1:15 and 1:25), and three irregular high-energy erosive wave conditions and one low-energy acc... ver más