|
|
|
|
|
Bin Xie, Jiaxiang Xue, Xianghui Ren, Wei Wu and Zhuangbin Lin
Adopting the cold metal transfer plus pulse (CMT + P) process, 316L stainless steel wire was treated with a single channel multi-layer deposition experiment under different linear energy. The microstructures of different regions on the deposited samples ...
ver más
|
|
|
|
|
|
|
|
|
Leander Schmidt, Klaus Schricker, Jean Pierre Bergmann and Christina Junger
Spatter formation is a major issue in deep penetration welding with solid-state lasers at high welding speeds above 8 m/min. In order to limit spatter formation, the use of local gas flows represents a technically feasible solution. By using the gas flow...
ver más
|
|
|
|
|
|
|
|
|
Totok Suwanda,Rudy Soenoko,Yudy Surya Irawan,Moch Agus Choiron
Pág. 38 - 43
In the previous study, Continuous Drive Friction Welding (CDFW) had been investigated to determine the strength of joining, burn off, and temperature distribution. In this study, Dissimilar Metal CDFW was studied to assess temperature cycle analysis. Alu...
ver más
|
|
|
|
|
|
|
|
|
Hiba Khalid Hussein,Israa Rafie Shareef,Iman Ahmed Zayer
Pág. 57 - 64
The Resistance Spot Welding (RSW) represents one of the most important welding processes. The resistance spot welding quality depends on the process parameters like welding current, electrode force and welding time and their chosen levels. In this work, ...
ver más
|
|
|
|
|
|
|
|
|
Miikka Karhu, Veli Kujanpää, Harri Eskelinen and Antti Salminen
In thick section laser welding, filler metal addition is usually required to improve joint fit-up tolerances or to control the chemical composition of the weld metal. With deep and narrow welds produced using an over-alloyed filler metal, it may be chall...
ver más
|
|
|
|