Cellulose Nanofibre Mesh for Use in Dental Materials

Resumen

The aim of this study was to produce a 3D mesh of defect free electrospun cellulose acetate nanofibres and to use this to produce a prototype composite resin containing nanofibre fillers. This might find use as an aesthetic orthodontic bracket material or composite veneer for restorative dentistry. In this laboratory based study cellulose acetate was dissolved in an acetone and dimethylacetamide solvent solution and electrospun. The spinning parameters were optimised and lithium chloride added to the solution to produce a self supporting nanofibre mesh. This mesh was then silane coated and infiltrated with either epoxy resin or an unfilled Bis-GMA resin. The flexural strength of the produced samples was measured and compared to that of unfilled resin samples. Using this method cellulose acetate nanofibres were successfully electrospun in the 286 nm range. However, resin infiltration of this mesh resulted in samples with a flexural strength less than that of the unfilled control samples. Air inclusion during preparation and incomplete wetting of the nanofibre mesh was thought to cause this reduction in flexural strength. Further work is required to reduce the air inclusions before the true effect of resin reinforcement with a 3D mesh of cellulose acetate nanofibres can be determined.