Inicio  /  Aerospace  /  Vol: 9 Par: 10 (2022)  /  Artículo
ARTÍCULO
TITULO

Numerical Investigation on the Jet Characteristics and the Heat and Drag Reductions of Opposing Jet in Hypersonic Nonequilibrium Flows

Wenqing Zhang    
Xiaowei Wang    
Zhijun Zhang and Tianyi Su    

Resumen

We adopted the transient numerical method for the simulation of an ELECTRE vehicle with an opposing jet at an altitude of 53.3 km and 13 Ma to explore the jet characteristics as well as the performance in heat and drag reductions of the opposing jet in hypersonic nonequilibrium flows. The time-accurate, nonequilibrium N-S equations coupled with the five-species Park chemical kinetic model and vibrational energy excitation were applied, and an open source solver Hy2FOAM based on the OpenFOAM platform was adopted. Three opposing jets with different jet radii (R7 jet, R14 jet, and R21 jet) were investigated. The results show that with the increasing jet flow rate, the jet mode of the opposing jet with a small jet radius varies from the overflow mode to the long penetration mode (LPM) and finally to the short penetration mode (SPM), while that with a large jet radius directly changes from the overflow mode to the SPM. The state of the jet in the overflow mode is stable, whereas in SPM and LPM, it is unstable. The investigation of the heat and drag reductions for the R7, R14, and R21 jets shows that except for the jet in LPM, the jet in SPM and overflow mode can provide effective thermal protection, and the thermal protection is enhanced with the increasing jet flow rate. Moreover, the jet in both LPM and SPM can effectively reduce the aerodynamic drag, but the jet in overflow mode cannot provide effective drag reduction. Moreover, the jet with a large radius and in the overflow mode has a better thermal protection effect, and a small jet radius contributes to the drag reduction.

 Artículos similares

       
 
Wenjie Shen, Suofang Wang and Xiaodi Liang    
Impellers are utilized to increase pressure to ensure that a radial pre-swirl system can provide sufficient cooling airflow to the turbine blades. In the open literature, the pressurization mechanism of the impellers was investigated. However, the effect... ver más
Revista: Aerospace

 
Chengze Wang, Huawei Lu, Xiaozhi Kong, Shiqi Wang, Dongzhi Ren and Tianshuo Huang    
The high curvature of modern S-ducts causes a strong secondary flow, which seriously affects the uniformity of the compressor inlet flow. In this study, the flow control method of a pulsed jet was applied in the S-duct at an incoming Mach number of 0.4. ... ver más
Revista: Aerospace

 
Tao Zhang, Xinyu Song, Xingping Kai, Yeguang He and Rundong Li    
In order to understand the breakup characteristics of a transverse liquid jet flow in an actual combustion chamber, a numerical study was conducted using the Volume of Fluid (VOF) method combined with grid adaptation technology. The study focused on the ... ver más
Revista: Aerospace

 
Wenqiang Dong, Ligang Yao and Weilin Luo    
A model of a submerged angular cavitation nozzle is established, which consists of a contraction part, parallel middle part, and expansion part. Based on the CFD technique, a numerical simulation of the flow field of the submerged cavitation nozzle is ca... ver más
Revista: Applied Sciences

 
Francesco Petrosino and Mattia Barbarino    
Scientific research studies on jet noise generation have been ongoing since the early 1950s, when turbojets were first used in commercial aircraft. Several numerical methods have been developed with the aim of reducing the environmental issues related to... ver más
Revista: Aerospace