Inicio  /  Aerospace  /  Vol: 11 Par: 1 (2024)  /  Artículo
ARTÍCULO
TITULO

Design of Convergent and Accurate Guidance Law with Finite Time in Complex Adversarial Scenarios

Hang Ding    
Dongdong Wang    
Chuanjun Li    
Xiao Liang and Xingcheng Li    

Resumen

The target can deceive the flight vehicle by releasing an infrared decoy to make the line-of-sight (LOS) angle rate deflect greatly, thus causing the flight vehicle to miss the target. Therefore, in order to accurately strike the target in complex adversarial scenarios, this paper proposes a finite-time convergence guidance law (FTCG) combined with a finite-time disturbance observer (FTDO). The complex adversarial scenario is established by combining the relative motion model between the flight vehicle and the target and the motion model of the infrared decoy. Based on this, considering the dynamic characteristic of the flight vehicle?s autopilot, a guidance model is obtained. Utilizing sliding mode control theory and finite-time control theory, an FTCG of the LOS angle rate is designed. Then, the finite-time convergence of the guidance law is proved and the total convergence time is derived. Finally, for the target maneuvering that is difficult to measure in the guidance law, an FTDO is used to estimate and compensate for the target maneuvering in the guidance law. Simulation results show that the FTCG can make the LOS angle rate quickly converge and accurately strike the target in different scenarios, with a good guidance accuracy and robustness. Compared with the sliding mode guidance law (SMGL) and the adaptive sliding mode guidance law (ASMGL) based on an extended state observer (ESO), the advantages of the designed guidance law are illustrated. Finally, FTCG is extended to be three dimensional and compared with the proportional navigation guidance law (PNG) to further illustrate its effectiveness in a three-dimensional coordinate system.

 Artículos similares

       
 
Saverio Cosola, Paolo Toti, Enrico Babetto, Ugo Covani, Miguel Peñarrocha-Diago and David Peñarrocha-Oltra    
Background: The present in vitro study aimed to investigate the fatigue performance of different dental fixtures in two different emergence profiles. Biological failures are frequently reported because the problem canonly be solved by replacing a failing... ver más
Revista: Applied Sciences

 
Dominique Fleischmann and László Könözsy    
This paper focuses on the development of an explicit finite difference numerical method for approximating the solution of the inhomogeneous fourth-order Euler?Bernoulli beam bending equation with velocity-dependent damping and second moment of area, mass... ver más
Revista: Aerospace

 
Carlo Cravero, Davide De Domenico and Andrea Ottonello    
One of the main issues addressed in any engineering design problem is to predict the performance of the component or system as accurately and realistically as possible, taking into account the variability of operating conditions or the uncertainty on inp... ver más
Revista: Algorithms

 
Xinyao Li and Liangli He    
The geotechnical centrifuge applied in various geotechnical engineering fields provides physical data for investigating mechanisms of deformation and failure and for validating analytical and numerical methods by simulating and studying the geotechnical ... ver más
Revista: Applied Sciences

 
J.C. Edison, Harish Kumar Singla    
The objective of the paper is to develop a validated scale to measure the factors that cause delays in infrastructure projects. The study employed a standard three phase scale development procedure of Churchill (1979) which was augmented subsequently by ... ver más