ARTÍCULO
TITULO

Microscopic observation of cold-deformed Al?4Cu?Mg alloy samples after semi-solid heat treatments;

Haitao Jiang and Miaoquan Li    

Resumen

No disponible

 Artículos similares

       
 
Yimeng Zhou, Cheng Zhao, Chunfeng Zhao, Chuangchuang Ma and Junfei Xie    
The artificial fracturing technique under coupled hydro-mechanical effects is widely used in many rock engineering. Therefore, the study on the fracturing behaviors and mechanical properties of hydro-mechanical coupled cracks is very crucial. In this stu... ver más
Revista: Water

 
Minghao Wang, Ziyu Wang, Deyu Li and Ning Li    
Topography observation of the nanoscale passivation film on tinplate using a scanning electron microscope and an electro-optical surface profilometer showed that it was difficult to observe the true topography because of the high surface roughness of the... ver más
Revista: Coatings

 
Jan Tomastik, Radim Ctvrtlik, Martin Drab and Jan Manak    
The scratch test, as probably the most widespread technique for assessment of the adhesive/cohesive properties of a film–substrate system, fully depends on reliable evaluation based on assessment of critical loads for systems’ failures. Tradi... ver más
Revista: Coatings

 
Shinji Tanaka, Naoyuki Hasegawa, Daisuke Iizuka, Fumihiko Nakamura     Pág. 199 - 207
Weaving section is one of the major bottlenecks in urban expressway network. A field observation showed that approximately 80% of the weaving vehicles changed their lanes within the most upstream 25% part of the entire section length. It means an insuffi... ver más

 
Yong X. Gan, Anan S. Hamdan, Jeremy B. Gan and Mingheng Li    
In this work, a Bi-Te-Ni-Fe complex coating material was obtained on magnesium oxide substrate by a single step ambient pressure chemical vapor deposition (CVD). Nickel acetate, bismuth acetate, iron (III) nitrate, and tellurium (IV) chloride dissolved i... ver más
Revista: Coatings