ARTÍCULO
TITULO

Power Amplifiers - Optimum Table Spacing in Predistorting Amplifier Linearizers

Cavers    
J K    

Resumen

No disponible

 Artículos similares

       
 
Fabian Meylahn and Benno Willke    
The continuous improvement of current gravitational wave detectors (GWDs) and the preparations for next generation GWDs place high demands on their stabilized laser sources. Some of the laser sources need to operate at laser wavelengths between 1.5 &... ver más
Revista: Instruments

 
Diaaeldin Abdelrahman, Christopher Williams, Odile Liboiron-Ladouceur and Glenn E. R. Cowan    
To mitigate the trade-off between gain and bandwidth of CMOS multistage amplifiers, a receiver front-end (FE) that employs a high-gain narrowband transimpedance amplifier (TIA) followed by an equalizing main amplifier (EMA) is proposed. The EMA provides ... ver más

 
Gianluca Giustolisi and Gaetano Palumbo    
In this paper, a new strategy for the design of ultra-low-power CMOS operational transconductance amplifiers (OTAs), using the ????/???? g m / I D approach, is proposed for the Internet-of-things (IoT) scenario. The strategy optimizes the speed/dissipat... ver más

 
Anindita Paul, Mario Renteria-Pinon, Jaime Ramirez-Angulo, Ricardo Bolaños-Pérez, Héctor Vázquez-Leal, Jesús Huerta-Chua and Alejandro Diaz-Sánchez    
An approach to implement single-ended power-efficient static class-AB Miller op-amps with symmetrical and significantly enhanced slew-rate and accurately controlled output quiescent current is introduced. The proposed op-amp can drive a wide range of res... ver más

 
Tapas Kumar Paul, Radha Raman Pal     Pág. 262 - 281
This study introduces a third order filter and a third order oscillator configuration. Both the circuits use two voltage difference transconductance amplifiers (VDTAs) and three grounded capacitors. By selecting the input and output terminals properly, c... ver más