Inicio  /  Applied Sciences  /  Vol: 12 Par: 10 (2022)  /  Artículo
ARTÍCULO
TITULO

Deformation Characteristics of Bolted Rock Joints under Compression-Shear Load

Bo Liu    
Hang Lin and Yifan Chen    

Resumen

Joints exist widely in tunnel engineering. Studying the deformation characteristics of the bolted joint is beneficial for preventing rock mass disasters. To reveal the deformation characteristics of bolted rock joints, the elastic solutions of the radial deformation characteristics of bolted rock joints under compression-shear load were derived, which were based on the Lame solution in elastic mechanics and the displacement coordination condition of the interface between the bolt and the joint (assuming that the displacement at the interface between the bolt and joint is equal). Then, the distance from any point of the compression-shear side of the joint to the center of the bolt was denoted as r. The minimum of the radial displacement of the joint at the compression-shear side urmin was calculated. Numerical simulation verified the correctness of the elastic solutions by calculating the influence range and distance. In addition, the variation law of the value of the radial displacement (ur) was analyzed and discussed by changing the elastic modulus of the rock block (Er), radius (R), and elastic modulus (Eb) of the bolt. The results indicate the following: (1) The radial displacement will decrease as r decreases; the influence range of the bolt on the joint is approximately an ellipse, whereas the long axis of the ellipse is equal to the influence distance of the bolt. (2) The influence distance of the bolt is roughly six times the bolt radius (6R). (3) The radial displacement shows an exponential relationship with the elastic modulus of the rock and a nonlinear negative correlation with the radius and elastic modulus of the bolt. The increase in the elastic modulus of the rock, the elastic modulus, and the radius of the bolt will make the radial displacement smaller.

 Artículos similares

       
 
Guohong Chen, Peng Cai, Jiewei Zhan, Yueqiao Yang, Zhaowei Yao and Zhaoyue Yu    
Since the beginning of spring 2022, successive landslides have occurred in the eastern pit slope of the Wolong Coal Mine in Qipanjing Town, Otog Banner, Inner Mongolia, which has adversely affected the mine?s production safety. This study aims to reveal ... ver más
Revista: Applied Sciences

 
Weiyuan Zhu, Jiaqi Cheng, Yutao Pang, Hongbin An, Junpeng Zou, Jie Ren and Cheng Zhang    
This study proposes a new form of underground diaphragm wall foundation with hexagonal sections, called the grid pile foundation (GPF), which is used for long-span bridges. To investigate the lateral bearing capacity characteristics of the integrated pil... ver más
Revista: Applied Sciences

 
Hao Wu and Yongsheng Jia    
In rock engineering, the dynamic loads caused by mechanical action and rock blasting have an extremely significant influence on the stableness of surrounding rock masses. To examine the impact of dynamic load on the mechanical properties and fracturing c... ver más
Revista: Applied Sciences

 
Gang Yao, Guifeng Wang, Lihai Tan, Yinfeng Zhang, Ruizhi Wang and Xiaohan Yang    
To study the influence of inclusions on the fracture evolution and mechanical properties of mortar structures, a series of uniaxial compression tests for mortar samples containing cylinder inclusions of varying mechanical properties were conducted. The d... ver más
Revista: Applied Sciences

 
Yadong Zhu, Haifeng Jiao, Shihui Wang, Wenbo Zhu, Mengcheng Wang and Songshan Chen    
In order to study the pressure pulsation characteristics and structural dynamic response characteristics of a vertical shaft cross-flow pump, this study used a computational fluid dynamics (CFD) numerical simulation method to analyze the pressure pulsati... ver más
Revista: Water