Resumen
Shear modulus (SM) and damping ratio (DR) are significant in seismic design and the performance of geotechnical systems. The evaluation of soil reactions to dynamic loads, such as earthquakes, blasts, train, and traffic vibrations, necessitates the estimation of dynamic SM and DR. The aim of this research is to determine the cyclic parameters of unsaturated soils in and around Peshawar, and how these properties depend upon the varied confining pressures and shear strains. Undisturbed samples were collected using Shelby tubes from five boreholes at different locations along Jamrud Road, Peshawar. The index properties (grain size distribution, plasticity index, and specific gravity) and dynamic properties of these samples were determined. Three samples of 100 mm in height and 50 mm in diameter were obtained from each Shelby tube. After preparing and mounting the sample in the triaxial cell, the sample is first saturated by increasing the cell and back pressures in increments of 50 kPa until the value of Skempton?s pore pressure parameter (B) reaches = 0.96. Samples were consolidated at confining pressures of 150, 200, and 300 kPa, then subjected to cyclic shear strains of 0.2, 1, 2, 2.5, and 5%. Shear stress?strain hysteresis loops were plotted, and the values of SM and DR were calculated for each cycle. Generally, at shear strains of 0.2 and 1%, the slope of the loops is steep, and gradually becomes gentler at higher strains of 2, 2.5, and 5%. It is found that, with an increasing number of cycles, the SM and DR decrease. The SM decreases with increasing shear strain, whereas the DR increases at shear strains of 0.2?1%, then decreases for strains of 2, 2.5, and 5%. The confining pressure has more influence at a shear strain of 0.2?1%, while little effect has been observed at a shear strain of 2.2?5%. The values of SM are higher at higher confining pressures at a given shear strain. The results show higher stress values during the initial cycles because of the greater effective stress that developed in response to shear strain while, with an increase in the number of cycles, the pore water pressure gradually increases, thereby reducing the effective stress and weakening the bonds between soil particles. In dynamics, when the confining pressure increases, particles are closer to contact, so the travel paths of waves increase. The energy loss will increase, so DR will decrease.