|
|
|
|
|
Jinze Sun, Shujie Liu, Jiwei Zhang, Qinghao Tian, Zhijie Yu and Zuodong Xie
As a widely used material in underground engineering, clay?cement slurry grouting is known for its initial poor anti-seepage and filtration capacity, the low strength of the resulting stone body, and its tendency towards brittle failure. To explore effic...
ver más
|
|
|
|
|
|
|
|
|
Wenle Gao, Yuming Kou, Tongqing Yan, Hong Sun and Saijiang Li
Blasting demolition plays an important role in building demolition, and numerical-simulation methods can facilitate the optimization of blasting-demolition schemes. To study the influence of the delay-time differences between columns on the blasting and ...
ver más
|
|
|
|
|
|
|
|
|
Shahrokh Maalek, Reza Maalek and Bahareh Maalek
This paper examined the opportunities of composite double-layer grid superstructures in short-to-medium span bridge decks. It was empirically shown here that a double-layer grid deck system in composite action with a thin layer of two-way reinforced conc...
ver más
|
|
|
|
|
|
|
|
|
Sajjad Sayyar Roudsari, Liviu Marian Ungureanu, Soheil Soroushnia, Taher Abu-Lebdeh and Florian Ion Tiberiu Petrescu
The ductility and strength of reinforced concrete (RC) columns could be noticeably improved by replacing steel bars with polymeric bars. Despite the previous research on RC columns, most of those studies focused only on the lateral load capacity of this ...
ver más
|
|
|
|
|
|
|
|
|
Yogesh Gandhi and Giangiacomo Minak
Topology Optimization (TO) recently gained importance due to the development of Additive Manufacturing (AM) processes that produce components with good mechanical properties. Among all additive manufacturing technologies, continuous fiber fused filament ...
ver más
|
|
|
|