Lateral force calibration in atomic force microscopy: A new lateral force calibration method and general guidelines for optimization

Artículos similares

Body Force Model Implementation of Transonic Rotor for Fan/Airframe Simulations

Acceso

Andrea Magrini

Three-dimensional throughflow models represent a turbomachinery cascade via a force distribution without the need for detailed geometric modelling in the numerical solution, saving consistent computational resources. In this paper, we present the applica... ver más

Revista: Aerospace

Design and Experimental Validation of a Micro-Newton Torsional Thrust Balance for Ionic Liquid Electrospray Thruster

Acceso

Ying Zhang, Dawei Guo and Yuntian Yang

This work describes the advances on a micro-newton torsional thrust balance for ionic liquid electrospray thruster (ILET) being developed in the National University of Defense Technology. The torsional thrust balance adopts an asymmetric pendulum arm abo... ver más

Revista: Aerospace

Fragmentation Characteristics of Seafloor Massive Sulfides: A Coupled Fluid-Particle Flow Simulation

Acceso

Huan Dai, Hao Li and Yan Li

The research on the fragmentation mechanism of seabed minerals under high ambient pressure significantly contributes to the exploitation of seafloor massive sulfides (SMS). In this paper, the uniaxial compressive strength (UCS) test and triaxial compress... ver más

Revista: Journal of Marine Science and Engineering

Experimental Investigation of the Performance of a Tuned Heave Plate Energy Harvesting System for a Semi-Submersible Platform

Acceso

Kun Liu, Haizhi Liang, Jingpin Ou, Jiawei Ye and Dongjiao Wang

Heave plates are widely used for improving the sea keeping performance of ocean structures. In this paper, a novel tuned heave plate energy harvesting system (THPEH) is presented for the motion suppression and energy harvesting of a semi-submersible plat... ver más

Revista: Journal of Marine Science and Engineering

The Effectiveness of Diamond-like Carbon a-C:H:Si Coatings in Increasing the Cutting Capability of Radius End Mills When Machining Heat-Resistant Nickel Alloys

Acceso

Sergey N. Grigoriev, Marina A. Volosova, Sergey V. Fedorov, Mars S. Migranov, Mikhail Mosyanov, Andrey Gusev and Anna A. Okunkova

The main purpose of this paper was to study the efficiency of using diamond-like carbon (DLC) coatings based on a-C:H:Si with a pre-formed CrAlSiN sublayer to increase the cutting ability of ball end mills made of KFM-39 cemented carbide at a speed of 15... ver más

Revista: Coatings

Artículos similares

Revistas destacadas