Active Pressure for Circular Cut with Berezantzev's and Prater's Theories, Numerical Modeling and Field Measurements

Artículos similares

A Numerical Study on the Flap Side-Edge Noise Reduction Using Passive Blowing Air Concept

Acceso

Yingzhe Zhang, Baohong Bai, Dakai Lin and Peiqing Liu

The flap side-edge is a vital contributor to airframe noise. In this study, we propose a novel flap side-edge noise reduction method based on the concept of active blowing air. A long slot is opened from the flap?s lower surface to the tip surface to ind... ver más

Revista: Aerospace

Intelligent Medical Velostat Pressure Sensor Mat Based on Artificial Neural Network and Arduino Embedded System

Acceso

Marek Kciuk, Zygmunt Kowalik, Grazia Lo Sciuto, Sebastian Slawski and Stefano Mastrostefano

The promising research on flexible and tactile sensors requires conducting polymer materials and an accurate system for the transduction of pressure into electrical signals. In this paper, the intelligent sensitive mat, based on Velostat, which is a poly... ver más

Revista: Applied System Innovation

Prediction of Reinforcement Connection Loads in Geosynthetic Reinforced Segmental Retaining Walls Using Response Surface Method

Acceso

Wan Zhang and Jianfeng Chen

This paper presents an improved earth pressure method that considers the capacity of a wall toe to carry an earth load to predict the connection loads of GRS segmental walls constructed with cohesionless backfills on competent foundations. In this method... ver más

Revista: Applied Sciences

Optimization Design of Pressure Hull for Long-Range Underwater Glider Based on Energy Consumption Constraints

Acceso

Jianxing Zhang, Baoren Li, Yuxuan Peng, Daming Zou and Gang Yang

Underwater gliders are a class of ocean observation equipment driven by buoyancy, and their energy consumption source is mainly generated by the active regulation of buoyancy. The periodic elastic deformation of the pressure hull during the upward and do... ver más

Revista: Journal of Marine Science and Engineering

Perforation Characteristics of Three-Layer Steel Plates Subjected to Impact with Different Shapes and Velocities of Reactive Fragments

Acceso

Huanteng Sun, Yunzhu Ma and Qingshan Cai

In this paper, the AUTODYN/Smoothed Particle Hydrodynamics (SPH) method was used to study the impact of reactive fragments on three-layer equidistant steel plates. The perforation characteristics of equidistant three-layer steel plates were investigated ... ver más

Revista: Applied Sciences

Artículos similares

Revistas destacadas