Redirigiendo al acceso original de articulo en 19 segundos...
ARTÍCULO
TITULO

Numerical Steady and Transient Evaluation of a Confined Swirl Stabilized Burner

Federica Farisco    
Luisa Castellanos    
Jakob Woisetschläger and Wolfgang Sanz    

Resumen

Lean premixed combustion technology became state of the art in recent heavy-duty gas turbines and aeroengines. In combustion chambers operating under fuel-lean conditions, unsteady heat release can augment pressure amplitudes, resulting in component engine damages. In order to achieve deeper knowledge concerning combustion instabilities, it is necessary to analyze in detail combustion processes. The current study supports this by conducting a numerical investigation of combustion in a premixed swirl-stabilized methane burner with operating conditions taken from experimental data that were recently published. It is a follow-up of a previous paper from Farisco et al., 2019 where a different combustion configuration was studied. The commercial code ANSYS Fluent has been used with the aim to perform steady and transient calculations via Large Eddy Simulation (LES) of the current confined methane combustor. A validation of the numerical data has been performed against the available experiments. In this study, the numerical temperature profiles have been compared with the measurements. The heat release parameter has been experimentally and numerically estimated in order to point out the position of the main reaction zone. Several turbulence and combustion models have been investigated with the aim to come into accord with the experiments. The outcome showed that the combustion model Flamelet Generated Manifold (FGM) with the k-ω" role="presentation">??? ? turbulence model was able to correctly simulate flame lift-off.

 Artículos similares

       
 
Junfeng Liu, Yujun Hu, Ji Yao and Qing Zhang    
Tuned mass dampers (TMDs) are widely used as vibration damping devices in engineering practice. However, during use, TMDs inevitably exhibit some nonlinear characteristics that may negatively impact engineering applications. To improve the practical perf... ver más
Revista: Buildings

 
Riccardo Toracchio, Fabrizio Fontaneto and Koen Hillewaert    
This paper presents the numerical characterization of a highly loaded compressor by means of 3D unsteady RANS simulations. The focus is on critical flow structures and their evolution at different operating points of the machine. First, the numerical set... ver más

 
Romain Hottois, Arnaud Châtel and Tom Verstraete    
Numerical optimization methods are widely used for designing turbomachinery components due to the cost and time savings they can provide. In the available literature, the shape optimization of radial compressors mainly focuses on improving the impeller a... ver más

 
Junke Xu, Jiwei Zhu and Jiancang Xie    
The risk transmission mechanisms of urban river ecological management engineering projects are examined in this study. Using the Susceptible Exposed Infectious Recovered Susceptible (SEIRS) model for risk transmission, a model of risk propagation delay f... ver más
Revista: Water

 
Qian Yang, Suoping Li, Hongli Li and Weiru Chen    
To accurately estimate the service delay behavior of IEEE 802.11 networks, this paper comprehensively considers four main factors that affect the performance of IEEE 802.11 networks and establishes a service delay model with statistical characteristics. ... ver más
Revista: Future Internet