Resumen
In order to solve the problem of uniform and precise fertilizer discharge, based on experimental analysis of the uneven nature of single-screw fertilizer discharge, a double arc groove screw fertilizer discharger was designed based on the principle of the half-cycle superposition of the fertilizer discharge curve. The fertilizer discharge amount and the instantaneous fertilizer discharge characteristics of the double arc groove screw fertilizer discharger were theoretically analyzed, and the factors affecting the fertilizer discharge uniformity of the double arc groove screw fertilizer discharger were obtained, taking the pitch S, arc groove radius Rp and center distance as the test factors. Using the uniformity variation coefficient and fertilization accuracy as test indexes, the experimental indicators were evaluated through a quadratic universal rotation combination design experiment with three factors and five levels. The optimal parameters were pitch S = 35 mm, arc groove radius Rp = 17 mm and center distance a = 40 mm. The fertilizer discharger was produced based on the optimal parameter combination, and a bench verification test and a comparative test were carried out. The test results show that the uniformity variation coefficient of the bench test and the relative error between the fertilization accuracy and the simulation test are 5.60% and 5.52%, respectively, and there is little difference between them, which verifies the correctness of the simulation. The comparative test results show that the uniformity variation coefficient of the optimized double arc groove screw fertilizer discharger is 7.16%, the fertilization accuracy is 3.44% and the fitting curve equation R2 of fertilizer discharge flow is 0.998, all of which are significantly better than in the single-screw fertilizer discharger. We developed an electronic fertilizer discharge controller and conducted bench verification tests on it. The test results show that the average deviation between the measured fertilizer discharge capacity and the preset value of the double arc groove screw fertilizer discharger based on our self-developed controller is 2.78%. This fertilizer discharge device can precisely control fertilizer discharge, effectively solving the problem of uneven fertilizer discharge in single-screw fertilizer dischargers.