Resumen
Hydraulic systems may involve both pipelines and open channels, which challenges the hydraulic transient analysis. In this paper, a method of characteristics (MOC)-finite volume method (FVM) coupling method has been developed with the pipeline modelled using the MOC and the open channel modelled using the FVM. The coupling boundaries between these two simulation regions are developed based on Riemann invariants. The simulated parameters can be transmitted from the MOC region to the FVM region and in the reverse direction through the coupling boundaries. Validation of the method is conducted on a simple tank-pipe system by comparing the simulated result using 3D computational fluid dynamics (CFD) analysis. The new method is then applied to a prototype hydropower station with a sand basin located between the upstream reservoir and the turbines. The sand basin is modelled as an open channel coupled with the pipes in the system. The transient processes are also simulated by modelling the sand basin as a surge tank. The comparison with the results by the MOC-FVM coupling method shows the new coupling method can provide more reliable and accurate results. This is because the flow velocity in the horizontal direction in the sand basin is considered in the coupling method but neglected when the sand basin is modelled as a surge tank in the MOC.