Redirigiendo al acceso original de articulo en 24 segundos...
Inicio  /  Applied Sciences  /  Vol: 9 Par: 20 (2019)  /  Artículo
ARTÍCULO
TITULO

Effects of Water-Soaking Height on the Deformation and Failure of Coal in Uniaxial Compression

Ruipeng Qian    
Guorui Feng    
Jun Guo    
Pengfei Wang and Haina Jiang    

Resumen

The stability of water-preventing coal pillar plays an important role in preventing gob water inrush. The gob side of the water-preventing coal pillar is soaked in a certain height of mine water. Different soaking heights may affect the stability of coal pillars. Few studies have been conducted on the properties of coals with different water-soaking heights. We carried out uniaxial compressive tests on coal specimens with different water-soaking heights to gain a better understanding of different water-soaking-height-induced weakening characteristics of coal. Results show that: (1) The water content of coal specimens increases with the soaking height. Water significantly weakens the strength of coal specimens. However, the extent of strength weakening of the coal specimen does not increase with the increase of the soaked height. The strength of the fully soaked coal specimen is lowest among all groups of coal specimens. The strength of the three groups of partially soaked coal specimens is between the fully soaked coal specimens and the coal specimens without being soaked in the water. In the three groups of partially soaked coal specimens, the strength of the coal specimens increases with the increase of the soaking height. (2) The acoustic emission activities of complete water soaking and nonsoaking coal specimens are relatively concentrated, occurring mainly in unstable fracture expansion stage and post-peak destruction stage, and acoustic emission exhibits main-shock mode. Partially soaking coal specimens, especially the 25% water-soaking height and 50% water-soaking height coal specimens, produces obvious acoustic emission activities during the fracture expansion stabilization phase, and then generates more acoustic emission activities during the unstable expansion stage and the post-peak stage. The acoustic emission presents foreshock?main shock mode. (3) The softening effect of the water soaking on the coal specimens is obvious. It was further found that the deformation of coal specimens with partial water soaking is not synchronized in different layers, the nonuniform deformations of partially soaked coal specimens aggravate its damage.

 Artículos similares

       
 
Baifu An, Chenghao Cui, Jinfang Ren, Dongda Wang, Jiale Wang and Qiaomei Yi    
To study the influences of different mix proportions of materials on the ultrasonic p-wave velocity of coal slime based backfill materials, influences of four factors on the p-wave velocity of specimens were investigated by designing orthogonal tests and... ver más
Revista: Applied Sciences

 
Masood Ur Rahman and Jing Li    
This paper presents experimental investigations on epoxy mortar produced using industrial wastes. In some recent studies, coal bottom ash and polyethylene terephthalate (PET) waste have been chosen as a filler to replace sand, and fly ash and silica fume... ver más
Revista: Applied Sciences

 
Yinfeng Tang, Donghai Jiang, Tongxu Wang, Hengjie Luan, Jiangwei Liu and Sunhao Zhang    
In order to study the local deformation of an anchor bolt and the improvement in the shear strength of a structural surface under the misalignment of an anchorage structure surface, FLAC3D software was used to simulate granite, sandstone, and coal specim... ver más
Revista: Applied Sciences

 
Mingtao Gao, Hongyu Yan, Huiqiang Duan and Si Xiong    
The paper represents a test investigation of the mechanical properties and acoustic emission (AE) characteristics of low-strength coal specimens subjected to cyclic loading and unloading. From the lab tests, the following conclusions can be obtained: (1)... ver más
Revista: Applied Sciences

 
Zhiqi Wang, Xufei Gong and Xuebin Gu    
To study the mechanical properties and energy evolution characteristics of the shallow fractured coal in the Western China mining area, a series of triaxial compression tests was carried out on fractured coal specimens. The stress?strain curve, mechanica... ver más
Revista: Applied Sciences