Resumen
Clay soil has poor engineering properties such as poor permeability and low shear strength. Waste steel slag is an industrial by-product formed in the furnace during the steelmaking process which has high quality, durability, anti-slip properties, gelling, high permeability and good particle interlocking properties. Therefore, in order to improve the engineering properties of clay and increase the utilization rate of waste steel slag, the steel slag was mixed into the clay. Steel slag clay mix was used for the straight shear test, cyclic shear test and post-cyclic straight shear test. To investigate the strength characteristics, damping ratio, shear stiffness variation and mixed soil displacement at the reinforcement-soil interface under different steel slag dosing, vertical stress, moisture content and shear amplitude conditions. The test results show that steel slag can significantly improve the shear strength of the clay tendon-soil interface, and the improvement effect is better than the conventional material sand improved clay. The steel slag mix has a large damping ratio and shear stiffness, suggesting that it has good damping and energy dissipation properties. In this case, the shear strength, damping ratio and shear stiffness of the soil mix at 40% steel slag admixture are better. The shear strength of the steel slag mix is increased after cyclic loading compared to straight shear before cyclic loading. In addition, the water content has a greater effect on the shear strength parameters, shear stiffness and damping ratio of the steel slag clay mix compared to the vertical stress and shear amplitude. The test results can provide a theoretical basis for the replacement of sand by steel slag in improving clay soils.