Redirigiendo al acceso original de articulo en 18 segundos...
ARTÍCULO
TITULO

Design of a High Sea Wave Sensor System in Puger Beach

Ike Fibriani    
Januar Fery Irawan    
Alfredo Bayu Satriya    
Satrio Budi Utomo    
Widyono Hadi    
Widjonarko Widjonarko    
Khoiril Khoiril    

Resumen

Indonesia is an archipelagic country that has a very wide sea area. Thus, Indonesian sea has a huge potential of natural resources that can be utilized to grow the nation's economy. There are many occupations and efforts that can be done to increase the income from the sea and also to conserve it. Fishery is one of the most effective way to gain the sea resources; however, fishery is limited by the weather condition on the sea. This is also a problem that happened in Puger Beach. Puger Beach is located in the south Jember and it faces the Hindia Ocean, which means the weather condition is more dangerous for fishermen than other part of coastal. To ensure the safety of the fishermen, the weather condition on the sea must be evaluated and predicted before the fishery. This study designed a system to provide fishermen in Puger Beach an information about sea and beach weather condition which consist of wave height prediction, wind speed, temperature, humidity and weather prediction. The wind speed is obtained from self-designed anemometer system, the temperature is measured using LM35 sensor, and the humidity is assessed using DHT22. The wave height in the sea was predicted by calculating the wind speed value and effective average fetch value using neural network algorithm. The weather on the sea and on the beach were predicted by rain and light sensor. This weather prediction would be classified into three different results, namely raining, cloudy and bright. After some experiments, the result showed that the device can provide the information needed for fishermen and it has a high sensing accuracy. The humidity measurement had an average error of 1.1%, the temperature measurement had 1.42% average error, and 2.37% for the wind speed measurement. The wave height measurement system worked out and found the average wave height in Puger Beach 0.37 meters.

 Artículos similares

       
 
Monga F. Twite, Lukas W. Snyman, Johan De Koker, Adedayo Ademola Yusuff    
A low-cost heat-exchanger system that can be used in high-pressure/low-pressure isolated solar water-heating systems in South Africa was developed for household applications. The combination of a copper coil and electrical heater allowed for isolation of... ver más

 
Antonio Jiménez Ramos,Julio Rafael Gómez Sarduy,Juan Francisco Puerta Fernández,Yulier Jiménez Santana     Pág. 257 - 263
La experimentación es un método que contribuye a corroborar resultados obtenidos en los diferentes procesos que se desarrollan en la industria, para este caso el objetivo del análisis estadístico es encontrar la relación matemática existente entre el tie... ver más

 
Francisco Eneldo López Monteagudo,Carlos Alberto Olvera Olvera,María Auxiliadora Araiza Esquivel,Carlos Guzmán Martínez,Miriam Vilaragut Llanes,Abdiel Moisés Martínez Bañuelos,Domingo José Gómez Meléndez,Alfonso López Martínez     Pág. 3 - 13
The need for energy in the world has led to the search for new ways of electric power generation, among which is the use of fuel cells as a renewable source that does not contribute to environmental pollution and has high efficiency in energy conversion.... ver más

 
Tafadzwa Makonese, Christopher Bradnum    
Many cookstove programmes implemented around the world aimed to reduce fuel consumption and pollutant emissions through the dissemination and adoption of improved cookstoves. A study was carried out for the design of wood-burning cookstoves for low-incom... ver más

 
Imam Kusyairi     Pág. 89 - 96
Crash Box attached between bumper and chassis of a car serving as a kinetic energy absorber during the collision. In previous research, origami pattern crash box was tested at low speed, high speed, and frontal impact and oblique impact directions. They ... ver más