Redirigiendo al acceso original de articulo en 22 segundos...
ARTÍCULO
TITULO

Surface Characterisation of Kolk-Boils within Tidal Stream Environments Using UAV Imagery

James Slingsby    
Beth E. Scott    
Louise Kregting    
Jason McIlvenny    
Jared Wilson    
Ana Couto    
Deon Roos    
Marion Yanez and Benjamin J. Williamson    

Resumen

High-flow tidal stream environments, targeted for tidal turbine installations, exhibit turbulent features, at fine spatio-temporal scales (metres and seconds), created by site-specific topography and bathymetry. Bed-derived turbulent features (kolk-boils) are thought to have detrimental effects on tidal turbines. Characterisation of kolk-boils is therefore essential to inform turbine reliability, control, and maintenance strategies. It will also improve the understanding of potential ecological interactions with turbines, as marine animals use these sites for foraging. Unmanned aerial vehicle (UAV), or drone, imagery offers a novel approach to take precise measurements of kolk-boil characteristics (distribution, presence, and area) at the surface. This study carried out sixty-three UAV surveys within the Inner Sound of the Pentland Firth, Scotland, UK, over four-day periods in 2016 and 2018. Kolk-boil characteristics were examined against relevant environmental covariates to investigate potential drivers of presence and area. The results show that distribution at the surface could be predicted based on tidal phase, with current velocity significantly influencing presence above 3.0 m/s. The technique can be used to inform turbine development, micro-siting and provide better understanding of environmental implications of turbine operation. Finally, it highlights the suitability of UAVs for capturing rapid fine-scale hydrodynamic data in the absence of in situ measurements.

 Artículos similares

       
 
Inigo Sanz-Pena, Shanika Arachchi, Dhammika Halwala-Vithanage, Sanjaya Mallikarachchi, Jeewantha Kirumbara-Liyanage, Alison McGregor, Pujitha Silva and Nicolas Newell    
The plaster-casting method to create a scoliosis brace consists of mould generation and rectification to obtain the desired orthosis geometry. Alternative methods entail the use of 3D scanning and CAD/CAM. However, both manual and digital design entirely... ver más
Revista: Applied Sciences

 
Sarah Cryer, Filipa Carvalho, Terry Wood, James Asa Strong, Peter Brown, Socratis Loucaides, Arlene Young, Richard Sanders and Claire Evans    
The interface between land and sea is a key environment for biogeochemical carbon cycling, yet these dynamic environments are traditionally under sampled. Logistical limitations have historically precluded a comprehensive understanding of coastal zone pr... ver más

 
Thomas R. Shearwood, Mostafa R. A. Nabawy, William J. Crowther and Clyde Warsop    
Tailless aircraft without vertical stabilisers typically use drag effectors in the form of spoilers or split flaps to generate control moments in yaw. This paper introduces a novel control allocation method by which full three-axis control authority can ... ver más
Revista: Aerospace

 
Choi Yu Hui     Pág. 38
The implementation of biomass sources as carbon precursor to synthesise heterogeneous solid catalyst for biodiesel production had drawn attention from researchers because it was less expensive and could reduce the generation of biomass waste. In this res... ver más

 
Anthony Hughes, James Laird, Chris Ryan, Peter Visser, Herman Terryn and Arjan Mol    
The distribution and chemical composition of inorganic components of a corrosion-inhibiting primer based on polyurethane is determined using a range of characterisation techniques. The primer consists of a Li2CO3 inhibitor phase, along with other inorgan... ver más
Revista: Coatings