Resumen
Solvent engineering is one of the most widely applied preparation methods for the high- quality perovskite films. In this method, the choice of anti-solvent plays a very important role to improve the perovskite crystal quality. Here, we report a facile way to regulate the crystal quality of perovskite film by adjusting the ratio of toluene and diethyl ether in the mixed anti-solvent. Through the combination of characterization and measurements including scanning electron microscopy, the atomic force microscopy, X-ray diffraction, and the steady-state photoluminescence spectra, it reveals that the quality of perovskite films is obviously improved when the volume ratio of toluene to diethyl ether in the mixed anti-solvent is 1:1. The optimal device obtains power conversion efficiency of 16.96% with a short-circuit current density of 20.60 mA/cm2, an open-circuit voltage of 1.03 V, and a fill factor of 79.96%. At the same time, the device shows negligible current?voltage hysteresis and steady power output. Moreover, the stability of PSCs is significantly enhanced due to the perovskite film quality improvement by adopting 50% toluene mixed anti-solvent.