Resumen
The recharge efficiency during artificial groundwater recharge (AGR) is reduced primarily by clogging that is triggered by suspended particles. However, there are loopholes in the current standards of recharge-water quality for clogging control during AGR, and the threshold values of turbidity to prevent clogging have not been reasonably determined. In this study, secondary effluents from wastewater treatment plants (WWTPs) were injected into saturated sand columns to simulate the process of AGR. Batch experiments under different turbidity conditions were conducted, and the numerical modeling of particle transport and deposition was performed to assess the clogging processes. Theories of single-collector contact and interfacial interaction energy were applied to elucidate possible microcosmic mechanisms. The results showed that the diluted secondary effluent (SE) with turbidities of 0.540 ± 0.050, 1.09 ± 0.050, and 1.84 ± 0.060 NTU caused considerable clogging in the porous media, which decreased the relative hydraulic conductivities (K/K0) by 13.2%, 17.6%, and 83.6%, respectively. The filtered SE with a turbidity of 0.160 NTU did not cause clogging, and K/K0 was reduced by only 1.70%. The clogging was attributed to the deposition of suspended particles in the sand matrix because they have a high collision efficiency (0.007?1.98) and attachment efficiency (0.029?0.589 kBT). Finally, this paper recommends that the turbidity of the recharge water should not exceed 0.500 NTU during AGR practices.