Resumen
Interlayer soil is common in southern Xinjiang, because interlayer can reduce the infiltration rate of soil water. To simulate the interlayer soil in heavy saline?alkali cotton fields, this paper adopted a vertical one-dimensional infiltration test. T1 (315 mm), T2 (270 mm), and T3 (225 mm) and different interlayer positions (T5, 315 mm) and thicknesses of the interlayer (T6, 315 mm) with the same irrigation volume, as well as one perforation and sand filling treatment (T4, 315 mm), were set. The influence of different irrigation amounts, locations, and thicknesses of the interlayer and sand injection on water infiltration was analyzed. The analysis results showed that with the increase in irrigation amount, the water infiltration rate and the migration distance of the wet front increased, but did not penetrate to the bottom soil (90 cm). Under the same irrigation volume, the increase in interlayer thickness (T6) compared with the increase in interlayer position (T5), the change in soil moisture content in the upper and lower layers of the interlayer was greater, and the advance time of wetting front migration and cumulative infiltration were slightly higher. After tunneling and sand filling (T4), the infiltration rate of water was increased, the migration time of the wet front was reduced, and the profile water content of each soil layer was improved. The Kostiakov model could better simulate the water infiltration characteristics of interlayer soil with different profile configurations in heavily saline?alkali land. The results showed that in all of the treatments, only the wet front of the soil moisture reached 100 cm in the T4 treatment, and the maximum was only 87.8 cm in the other treatments, indicating that too little irrigation water or the upward movement and thickening of the interlayer were not conducive to water infiltration. For the interlayer soil area in the heavy saline?alkali land in southern Xinjiang, the appropriate irrigation water should be more than 315 mm. The treatment of drilling first and then filling sand can be used as a simple but effective measure to increase the water infiltration rate of the interlayer soil, and can thus be applied to the layered soil structure in the interlayer position of 60?80 cm.