Resumen
The methanation process is discussed as one way to chemically store renewable energy in a future energy system. An important criterion for its application is the availability of compact, low-cost reactor concepts with high conversion rates for decentralized use where the renewable energy is produced. Current research focuses on the maximization of the methane yield through improved temperature control of the exothermic reaction, which attempts to avoid both kinetic and thermodynamic limitations. In this context, traditional manufacturing methods limit the design options of the reactor and thus the temperature control possibilities. The use of additive manufacturing methods removes this restriction and creates new freedom in the design process. This paper formulates the requirements for a novel methanation reactor and presents their implementation to a highly innovative reactor concept called ?ADDmeth?. By using a conical reaction channel expanding from Ø 8 to 32 mm, three twisted, expanding heat pipes (Ø 8 mm in evaporation zone, Ø 12 mm in condenser zone) and a lattice structure for feed gas preheating and mechanical stabilization of the reactor, the design explicitly exploits the advantages of additive manufacturing. The reactor is very compact with a specific mass of 0.36 kg/kW and has a high share of functional volume of 52%. The reactor development was accompanied by tensile tests of additively manufactured samples with the used material 1.4404 (316 L), strength calculations for stability verification and feasibility studies on the printability of fine structures. Ultimate tensile strengths of up to 750 N/mm2 (at room temperature) and sufficiently high safety factors of the pressure-loaded structures against yielding were determined. Finally, the paper presents the manufactured bench-scale reactor ADDmeth1 and its implementation.